XT60i to O Ring Terminal Cable，More Than 8A，10AWG Extension Cable XT60i Female to O Ring Connector XT60i-f Compatible with Lipo Batterie (1.5M/5FT)

Well made cable for DC charging aLIFEPO4 portable solar power station. One of those gotta have if you need it items.Works well!

12awg wire insulated at 60C (which this product is) is rated for up to 20A of current. The Delta models from Ecoflow are limited to 15A of current on their XT60 port when using XT60i, so this is a perfect fit! Here you can see it connected to an AOLithium 100ah 12v LiFePO4 Battery which is plugged into our Delta 3.Works great and feels great. The leads leading up to the battery are barely wide enough to reach the terminals, so be careful if you have to split them at the insulation to make them reach. Luckily, I did not have to.

Use with my Ecoflow. I go from 100 watts charging through my cigarette lighter. To 200 watts from the battery. Good gauge wire. No complaints

Working great as an interface between my 12v eco-worthy lifepo batteries and my ecoflow delta 2 and 3. If I remember correctly, I get about 200 watts out of each batter at 12v with this cable.

Worked fine for connecting external battery to EcoFlo Delta 2. (You get about 200 watts transfer, so it slowly tops off the EcoFlow)

Well Made cable XT60I makes charging my Echoflow easier from external batteries

Cables are thick 10ga but still soft and malleable. Worked perfectly for what I needed.

Works well for using LiPo battery to double power station capacity. Has correct, and required, signal wire pre-installed.