Hoist Trolley for PA200-1000 Electric Hoist 6 Wheel Trolley Assembly for use with Unistrut 1-5/8" Wide and All 1-5/8" or Taller Strut Channel,Suitable for Garage Hoist Systems

These have worked out great for the hoist I installed in my shop. Fit as described, rolls smoothly and makes mounting hoist a snap.

They should work great, the ball bearings roll smoothly. However I mounted the strut channel differently and made a mistake using thin fender washers, which distorted and blocked the ability to travel inside the channel. We were able to raise the new AC Air Handler up into the attic with my HF 120vac powered wench and lowered the (old heavy Air Handler) out of the attic. These handled the load well. For that load, they are overkill, but I have another use for the future and will use the proper supports (which was ordered but wasn't delivered in time).

Worked great for lift with trolly I built to lift items to storage level of garage.

Used them on a barn hoist, 1200 gross lift, fit good, roll very easily even under load.

Excellent product while using my gantry

Beefy. Used on a 1300 lbs capacity winch. I used rail from HD without issue. Buy the corresponding mounting brackets and bumper stops and you will not be disappointed.They roll freely and fit my winch perfectly. Made mounting my winch effortless.Makes my winch more functional since I can move it around to work on car, remove convertible top and even used it to lift 450 lbs toolbox hutch onto roller cabinet.

First, because of the multiple wheels on each truck these are NOT compatible with curved or radius channel track designs. They will jamb tight in a curve. Only use these for straight track. These are really strong. Made of thick aluminum and it’s welded not bent. The wheel assembly fits perfectly in the conduit channel. I used this to hang a 440lb electric hoist in the storage loft over my shop. It’s actually much faster than I anticipated it would be. I’ve had no issues with service duty, it’s run for hours lifting boxes up & down. I retrofitted a 28ft extension ladder as a guide for a platform lift but instead of installing the hoist motor to the ladder as others have done I mounted it to the rafters.The lift is dedicated to this spot and doesn’t need to be portable so it makes sense to keep it simple.

Much better than expected!! Mounts directly to the VEVOR Electric Hoist 1760lbs, which I mounted on the garage ceiling with 1 5/8 X 1 5/8 unistrut. WAY Overkill for my intended use, but a convenient and economical alternative.