DC5-12V 0A-30A Dual-Channel H-Bridge Driver Motor Robot Stepper Driver Controller Board Module

Bon produit , livraison rapide .

Using this controller to drive a high output fuel pump from a 24kHz PWM control signal is 24kHz.35amp inrush on startup, and 12-18 amp continuous operation, the driver is going strong and within reasonable thermal limits. Nice value for the cost.

The media could not be loaded. I used this to make a breathing machine for testing intra-nasal devices. I needed to run a linear actuator with an arduino and a Nextion HMI, and this did the trick. It comes with zero technical info though, so I took off a star. Basically in order to use it, I used the Easy Nextion library, made my interface first. I declared the pins I would use on the arduino, and did some math to make it work out. I declared pins 10 and 11, and used the header on this board with ground, In1 and In2 connected to the arduino. Works great!

Works well, does its intended job.

This DC 5-12V Dual Channel H Bridge Motor Driver Board is a fantastic choice for controlling DC motors in robotics projects. The dual-channel design allows you to control two motors independently, and the wide voltage range (5-12V) makes it compatible with a variety of motors. The 30A current capacity is impressive, providing ample power for even demanding applications. I've been using it to control the motors on a small robot, and it's been working flawlessly, providing smooth and precise control.