Youteo 0.2mm, 0.3mm, 0.5mm Airbrush Nozzle Needles Replacement Parts for Airbrush Trigger Gun

Excellent product that repaired a blocked airbrush by replacing the nozzle so saved me money.Also impressed with the different needles and nozzle sizes so I can vary the spray painting for different jobs.

Yep no complaints here good job

Perfect so easy to change over

The first time fitting the 0.3 mm nozzle replacement, the thread sheared when screwing it into the airbrush. Part is now stuck in there and impossible to remove. My airbrush is now useless as I cannot fit another nozzle. The manufacturing quality of this item is terrible - DO NOT PURCHASE.

Item is fit for purpose but don't expect perfection. Two of the needles where deformed and one cap over all staderd packaging, will be OK for the occasional use by hobbyist. Would I buy again yes as a backup.

The .5mm needle, which was the reason I bought these, does not work. When fitted to my airbrush which has a .4mm as standard, the .5 does not allow any air to pass through. The kit should come with a replacement nozzle cap.

works well(so far ive only used it once) in my iwata neo but will not work in my harder and steenbeck ultra air brush totally wrong fitting

Be very careful with these. Needles seem decent from what I can tell but nozel broke in half and got stuck in the airbrush when I put it in. Not great quality.

good

After purchasing an airbrush and it not working properly, I pulled a brand new never used airbrush apart to find the nozzle was broken. Contacted the company to see if parts could be ordered or just simply returned for another (still waiting on a reply from them). While waiting I came across this kit. For $12 I took a chance and the nozzles and needles worked perfectly and now have a selection to choose from while using same air brush. Thanks for solving a problem the company hasn't bothered to address!

Parfait

Got this to see if I could use 3rd party parts for my Iwata Hp-BS. Iwata parts are expensive, and often take a long time to arrive/track down. I am also clumsy and have gone through 4 nozzles and 3 needles in the last 2 years.Needles:The 0.3mm works with the standard HP-BS/CS/SbS nozzle - it protrudes out a bit further, but otherwise seems to work nicely. Changes the rate of paint flow a bit, pulling back the same distance will allow less paint through, but that might enable beginners to get some finesse they couldn't achieve otherwise.I can only assume it is a similar story with the 0.5mm, I don't own that Iwata nozzle.The nozzle tips are INCOMPATIBLE.The threading of the nozzle tip fits the brass HP-BS/CS/SbS nozzles, HOWEVER, the length of them causes them to stick SO far out that it plugs the airflow. I attempted multiple combinations of O ring to try and get it to fit better, but the best I could achieve is a heavy backflow of air into the cup when the trigger is pressed down in the neutral position.Overall, I can get 2 of these kits for the price of one Iwata 0.35mm needle, and they have a 1 day delivery. I'll honestly probably just use these 0.3mm from now on. I think I'll pick up an Iwata 0.5mm nozzle to test as well.

Worked good