Innovative ScubaDive Wrench Stainless Steel Set

not for long... but it works and it is built strong IMHO

You need this in your save the dive kit. Fit is snug on sizing, requires some shimmering, but gets the job done well. Would purchase again

Great in a pinch for swapping out regs and hoses, but will chew up the nuts on your 1st and second stages. Plus metal is soft. Just don't use them ALL the time. Get a better tool for regular use. I keep a set in my save a dive kit.

I bought this product specifically for the wrench pictured with a 5/8" opening on one end and a 9/16" opening on the other. (This combo allows me to put a single wrench in my travel kit.) When they arrived, I discovered that the wrenches are actually 5/8"-1/2" and 9/16"-11/16".Fortunately I was able to open up the 1/2" jaw using a mill, but anyone without access to machining equipment will not be able to purchase the one-wrench solution that I expected when I chose this product.

The wrenches are thin and light-weight, so ideal for putting in the save-a-dive kit. Their thin-ness also allows them to be used in tighter places.However:- I had to use a metal file to open up one end by about 1mm because it was too tight/small for the specified size- The insides of each open end are curved, so you can't get a solid fit on the wrench flat- One of the open ends is a little loose, so you need to be careful you don't damage the wrench flat you're using it on (by flattening the corners of the wrench flat - hope that makes sense!)These are fine for occasional, save-a-dive use. They can't compare to proper tools, and perhaps they're not intended to.

Scuba diving, work great, And don’t over tighten your crap

Great set of wrenches if you need to call nnwct and disconnect hoses from your gear

Minimal but sturdy and imperial sizes are right for most standard regulator hoses.