Starlink Gen 3 Pipe Adapter, Starlink Gen 3 Mount, Starlink Pole Mount, Upgrade Durable Starlink Roof Mounting Pole Pipe Connectors Compatible Starlink Gen3 V3 Standard Dish Mounting Kit Accessories

This is a great mount, sturdy, and easy to install. It's easy to adjust, doesn't walk on the pole while tightening. Includes wrench.

We ordered this adapter to relocate the starlink antenna to a pole we had installed. It attached easily and is very secure. We live in western North Carolina and went through the recent hurricane and had no problems with the adapter coming loose. The retaining screws held tight. It’s a good price for a good product that is easy to install and puts your mind at ease!

This is the third time I have tried to post this review! That should tell you everything you need to know. I didn't use this mount but it was my fault - the verticle brace did not yield a level mount. I could not articulate the mount to exact the alignment so had to abandon this well designed and stout mechanical mount for an articulating one. Just get it if you have good LOS and few obstructions. We experienced a tornadic event with 40-60mph winds and it did NOT move! Good stuff.

This mount seems very sturdy and looks great on the PVC pole I made to mount it. I did not want to put the Starlink on my roof and wanted to be able to disassemble relatively easily if we had a bad storm coming. I think the mount is a little flatter than the 15° needed for optimum reception. I had to adjust my pole slightly off plumb to achieve the correct angle but it turned out ok. The ID of the connector fits great over a 1.5" pipe and the mounting screws secure it well.

We used this mount to attach Starlink satellite dish to our house. It is sturdy, affordable, looks good. We attached it with ease two ways. Chose a side mount for a lower profile,

I upgraded to the Gen 3 from the original Gen 1. I purchased this so I could place it on my original post for my Gen 1 and it kept telling me it was not at the correct tilt angle. I ended up bending my pole approximately 5 degrees to the north to make this mount work. (See pics) If your like me, this is something that will drive me crazy 🤣 so I will be looking for another one from a different manufacturer. I put an angle cut on the top of the post thinking this would help, but as soon as I would start to tighten the set screws it would end up out of alignment again. These all require the same angle, so I'm not sure why it would be so difficult to sell one that is made correctly.

The starlink gen 3 pipe mount fits my gen 3 perfectly. It perfectly mounts on my homes existing satellite mounting pole and attaches securely with absolutely no misalignment. Quick and easy install. Couldn’t ask for a better mount. Would recommend.

This product cracked all the way down when the screws were tightened enough to stop any rocking or movement (did not use a drill, hand tightened). The screws stripped and would not back out, so we would have to cut off the top of our pipe to get it off. Therefore I couldn't return it. I think it is best for areas that do not have windy conditions where it doesn't have to be tightened much. Seller delivery time is fantastic. May work for you, but not for us.