3D Printer Enclosure for Bambu Lab A1 Combo/A1 Mini Combo with AMS Lite,840X570X570mm Enclosure Large Size Fireproof Dustproof Tent Constant Temperature Protective Cover

Got this for a Bambu A1 Combo so that I could keep it in the garage without it getting filthy. Putting it together was super easy, even before I realized it came with instructions. The front opening is plenty to work in when setting up the printer and it has a side opening for changing out filament on the AMS without fully opening the front.The only down side is the cheapo thermometer/hygrometer it comes with. The thermometer reads low and the hygrometer reads excessively high. It's usually sitting in the 70-80% range despite other hygrometers reading 40-50%. Obviously that's not good with a 3d printer enclosure since you want to monitor humidity to ensure your filament isn't ruined or ruining your print. I'd recommend buying a different hygrometer to monitor your enclosure. You can find bluetooth or wifi enabled ones for really cheap so it's worth it to find a better one than try to rely on this thing.

While it works, it doesn't leave enough space in front of and behind the bed for it to move it's full range without the cable hitting the enclosure in the rear, and the bed hitting it in the front. While this hasn't caused any noticeable issues for me so far, I imagine this could cause some serious problems in certain circumstances.Quality is good enough overall, but the top has no center support and sags internally. The bowden tubes running between the AMS Lite and the hub will be permanently rubbing against the top of the enclosure unless you brace it somehow. I used some cheap 1/2" pine lath and just measured and cut it to sit secure on top of the frame. Mounted an EvaDry rechargable desiccant with motion activated led ring light to it as well.I enjoy the pockets and appreciate the included hygrometer. It was also very easy to assemble.

If you have a bamboo lab A1 or A1 mini either with or without an AMS, this enclosure allows you to run your printer in a much more stable temperature environment. Put a HEPA filter in there and you’ve got a little bit of air filtration to allow you to use your 3-D printer indoors much easier.

Works just as intended. Good quality. Easy setup.

It seems to be doing the job. I got it to try to control some of the moisture in the air from being absorbed by the filament of the 3-D printer. It literally took me 5 minutes to put together. The printer and AMS have plenty of room inside the tent. I may be able to even fit a small dehumidifier in there with the printer, right now I’m using silica gel desiccant packs which the tent has 3 pockets inside for. Over all its a good buy. I would of like to seen a built in led strip for light but I can always do that myself later.

The enclosure fits my Bambu A1 with AMS perfectly. Keeps heat in and moisture out. The only issue I have is it will not fit a reel of filament on the top. Other than that no complaints. I like being able to get to my AMS from the side to change reels. The only thing I may add is a light bar.

The product’s fiberglass frame poses significant safety risks. The fibers easily shed, causing skin irritation and are difficult to remove. Inhalation of these particles can lead to irreversible lung damage. Without proper protective measures, this product is not recommended.

My Bambu A1 is in the basement where temp can get a little low in the winter. I was having issues with prints not adhering to the bed because of that. Not a problem anymore. Just the heat from the printer and bed raises the temp to the mid 70's. My A1 and AMS fit great. If your printer is in a cooler space, I highly recommend getting this.