Gold Plated Pass Through RJ45 Cat6 Connector by itbebe 100 Pieces

I have purchased these a number of times now and apart from the fact that NO ONE has been on the phone offering me a repeat order discount ;-) I have absolutely nothing but positive comments and experience with this product. From order to receipt, seamless. For 100 pieces, your paying a fair amount more at the trade counter and usually when buying 100 you have a marginal percentage that will fail or are just knackered, it's an unwritten expectation that a couple would have been produced at 1 o'clock on a friday just before knocking off time and the quality inspector was in the bog. Not these, ZERO failure so far outta about 700. hugely impressed and happy. BUY THEM, I INSIST ......

Great

These are the best value for money and reliable connectors

Superb for cat5e cable, insert the wires, check the order of the colours, snip them off as close to the end of the plug as possible and carefully pull the wires back so the cut ends are level withe the end of the plug and crimp...Bingo, nice and easy. The cat6 cable that I use, the individual wires are too thick for the holes.

Just done a huge house renovation and filled the place with cat 7 cabling, then I realised that getting ends for these cables was going to be very difficult or very very expensive.Having tried a few products I eventually tried these ends and I'm so pleased I did, I'd been tearing my hair out.Inner cables fit snuggly in the end which holds them in place and makes the whole thing easier to wire, I'd definitely buy them again if I needed more.If you need wall sockets for cat 7 then look at the cat 6 ones from cable monkey, they work very well.Hopefully this helps?

Excellent product, well worth the price paid, best thing about these connectors is allowing for wires to pass through to open end of connector to check coloured Leads are in correct position before trimming back and then crimping once happy. I made my own RG45 cat 6 leads for CCTV project.

Great product. Make sure you have a pass-through crump tool which cuts the wires flush with the end of the plug.

I should have paid more attention to Doorman's review. Had exactly the same problem. My Cat6 solid core cables would not pass through the guide holes in the connector without huge difficulty. I also had to fiddle around with a 0.8mm drill bit held in my fingers to clean the burred interior of some of the holes as they were not smoothly moulded. Some connectors were fine but others required too much prep work. Also, when I did manage to wire one plug my RJ45 crimping tool (which I've successfully used for years) failed to close all the blades. Basic premise of pass-through wires is good but, in my case, qa sadly lacking. Maybe I got a bad batch but life is too short hence I'm returning.