Supershieldz (2 Pack) Designed for OnePlus 7 Pro and OnePlus 7T Pro Screen Protector, High Definition Clear Shield (TPU)

So affordable it's almost like stealing! Ease to apply (and has instructions for noobs. Sticks well. Ease to replace. Thickness is good, not bulky. Durable against falls, drops, slips, and the ever so present toss-on-bed-then-bounces-to-floor scenario we all wish we weren't familiar with. Screen stays safe against the occasional gravel/concrete skid.

Good but little difficult to get all bubbles out and I’m pretty good at putting these on

I have tried multiple screen protectors for my OnePlus 7t Pro 5G Mclaren edition, from tempered glass to hydro films. However, this is by far the best film protector I have ever had. No bubbles, fingerprint sensor works great. It looks like there is nothing on the screen. This a well done product!

So the colors look great with glass instead of TPU. But unfortunately the glue is not enough to keep it in place.The round edges of the phone makes it harder to align it properly.So, when you use a hard case for protection, your bound to pop the screen protector off.Here's the best thing to do:Set your background for the lock screen to a gray color. It will allow you to see the icons and speaker better so that you don't cover them with the glass. Set the display timeout to at least 5 or 10 minutes. Of course during placement, you have to turn the phone on, but you don't have to unlock it.Follow the instructions, and try as best as you can to align it below the top speaker and that the edges are leaving the same amount of space on both sides.If you fail take off, and try again. Pay close attention to the dust, because every time you remove it, dust can land on the phone screen. And be careful with every alignment, because dust can be trapped on the glue inside the glass. You can't remove that dust, you just smudge the inside.And my best tip: when you got it set, use a blow dryer hot air and heat up the glass.The point is to get the glue to soften.And have a clean cloth ready to press down on all areas of the glass. Heat it up again if you have to and repeat the process.Make sure the glass doesn't move off, so be careful in the way you press it down.Put pressure on the edges as well.The glass and glue separation from the phone screen makes a sound, can't describe it but you'll know. Heat up those areas or the entire screen again and press down.Good luck 🤞

Works great

This is waste of money don't buy it is a house of bubbles on the screen

This screen protector I highly recommend it's material was just a "Stick on" or just tempered glass like. It had 3-4 different was you can put it on your phones screen and it has the Type C hold at the bottom for a well seated guidance.

Easy application. Bubbles started appearing a few weeks later. After month or so the surface looks like Martian surface full of groves. It is definitely not hard material!