VCE RJ45 Cat6 Keystone Inline Coupler UL Listed 5-Pack, Female to Female PoE Ethernet Cable Extender UTP for Cat6/Cat5e/Cat5 Cable (Green)

These are really handy to have around. You can use them as a coupler in a pinch. I bought these to have around when I need to install a wired ethernet cable in the wall. I have a lot of blank plates that these fit. Much easier than doing punchdowns which I have always found to be a real pain.

Have made multiple purchases of these keystone couplers over time and have always found them to fit panels well, retain cables when connected, and provide good signal pass-through. As far as I am concerned, they're well suited to purpose.One benefit is that they're actually a bit stiff to insert in the panel cut-outs. That's a good thing, because I have dealt with other couplers in the past which do not fit as snugly, and that has sometimes meant that they are prone to popping loose. that is not the case with these VCE couplers. They stay firmly attached once inserted.

Thes are great to use when you have wall outlets,and the cord already has the ends on them. These are just literally plug and play. These fit my keystone wall plates well.

These are typical Chinese plastic pieces, but they work. However, if you pull on them once theyre installed via a LAN network cable end, theyll disconnect and lose signal. That shouldn't matter much depending on the situation of the cable placement and mounting.

Works as expected

Great ethernet cable couplers that are durable in a wide temperature range of -10F to 150+F. I have a handful of these installed in an uninsulated attic for years, exposed to bare frigid winters and toasty oven summer highs. They replaced some cheap RJ45 couplers from the local 99c store. Network connectivity ever since has been flawless. Evidently, UL label products like these are much more reliable. Highly recommended!

Bought these to replace a defective one from another manufacturer that never properly seated in the wall plate - this VCE product clicked in firmly and withstands disconnecting and reconnecting without pushing in to the wall like the previous one did. I like these inline couplers as they can be used with premade cables without the need to use a punch down tool like is needed with bare CAT6.

AT&T left a mess with the Ethernet end of my fiber installation when they installed my internet. The keystone jack they used was left completely uncovered and dangling. It looked messy not to mention left it open to possible damage. Used this to cover the jack for its protection with some sticky tape to mount the keystone properly. Easy to install and makes my cabinet look much more professional.