Dental DistortionsBlack Pennywise FX Fangs 2.0 Evil Clown Costume Teeth

I received the product and was terrified about apply it. Instructions skimpy. I went to Amazon reviews for help and was worried with all the negative reviews about being unable to apply. Do this: Form veneers to your teeth as instructed using warm water. Boil some water in a cup (doesn't matter how much). Let cup stand for 1 minute then place 1/3 of the white beads in the cup (give or take, it doesn't matter, beads are reusable, and quantity used can be added to or subtracted. They give you plenty). The beads quickly turn clear and nicely clump together in the water. Remove the beads with a metal spoon and place on a saucer. The beads are now softened and can easily be formed into any shape with the fingers. Apply a thin film of softened material to the back of the lower set. It will stick nicely to the veneer but by the time you have done that, it will have cooled enough that you will not get them to stick to your teeth. So place the veneer/material combo back into the water for about 15 seconds to soften the material enough so that you can apply the veneer to your teeth. Remove the veneer, press firmly in place on your teeth and hold for 30 seconds. Voila! Repeat for the upper veneer. I wore these veneers for two hours with no problems. Talking a little difficult at first but improves greatly as you get used to wearing them. Realistic looking. Well worth the money.

The media could not be loaded. These are absolutely incredible.I followed to advice of the others and watched the adhesive tutorial before I started. I ended up having to fit them twice but I’m so happy I did. They aren’t super uncomfortable, the stay in place well, and they look absolutely incredible. I’m SO thrilled

Loved these but they are extremely expensive for what they are.

Bought two sets both of them are just cheap front covers the adhesive doesn’t work and it’s nearly impossible to fit them and maintain that shape.

The YouTube video is much easier to follow along with than the paper instructions. I heated a mug of water for 2 minutes in the microwave. The pellets are thermal plastic, not wax. They clump together on contact & turn clear when ready. I pushed the plastic through the holes with a (metal) mechanical pencil tip (using fingers was near impossible). I have permanent retainers on my upper and lower front teeth, so I re-fit the veneers by wiggling them gently on and off more than a person without retainers would to mash down any excess plastic that may have gone through while still hot. They fit snug and are actually comfortable to wear. I wouldn’t recommend the X-acto knife method cutting out the bits of excess between the teeth unless you’re a pro with one, the plastic is too hard and you risk damaging the fangs in the process if you fail. Just re-submerge the veneers in the hot water and push the excess out of the way when it turns pliable again. You may have to re-fit the veneers again after.

The veneers themselves are cool but the instructions for heating the plastic beads and molding were not great and it took so long to get them to set right. I tried over and over again. I wore them a week after I set them and pieces of plastic were breaking in my mouth after minutes. I could hardly talk (though I expected that). It made for a good picture but they were not very impressive.

Dude love these, I only use the top set because I have a horrible over bite but that fit perfectly to my teeth and are for the most part comfortable I slightly made mine TOO custom to my teeth that when they hardened they got tighter than wanted but they definitely stay put I don’t need anything else to hold them in place

These are so cool! The process was a little irritating but the thermal beads are super forgiving so I ended up having fun fitting them!Amateur tip: I popped my rapidly cooling mug of water into the microwave for 15 seconds and the beads turned clear pretty fast.