mlnyitus[ RGB & Dynamic Pattern ] led Light Decorations Flexible Helmet Lights Cosplay DIY kit RGB Superhero for Men Gifts - Dynamic Color RGB

This was my first time using these and they were very easy to use as a first timer. The leds didn’t stay on right and I had to glue them on to make them stay. I wish the power was slimmer or smaller but other than that. It was good

The product is as expected. Lightweight, perfect for putting into a helmet. The only problem that I had was the led beads that are put into the diffused panels unfortunately detach quite easily from one another. Nothing a little glue epoxy won't fix. Otherwise it's easy to see out of close up, and diffuses the light well. Overall, satisfied with the product.

They worked awesome. Had to reattach the flexible plastic lenses

They look amazing in the dark or in the light! Can see totally fine outside, in bright or in moderately lit rooms; although there are some things to know of before buying and implementing for costumes-Firstly, the cables from the power supply to the lenses are pretty short, so it’s something to consider with your project. Probably 3-4 inches, which sounds like a lot, but becomes a challenge depending on your cable management;Second, if you’re using these as eyes or lenses on a helmet or mask, be aware that there are two sides to the lenses. One is glossy and very smooth, and one slightly rougher; the rougher side is the one that will be on the inside of mask, facing towards your face. The light reflects of this rough side and projects outwards.Finally, you must remove the white film off of both sides of the lenses- but I recommend cutting them right where the taper starts, leaving a tiny bit to cover the leds and hold them in place; they will fallout otherwise and require tape or adhesive to remain in their slots.Also, be very gentle with the edges of the lenses, the reflective foil must remain on them for the lights to properly illuminate. All this sounds like a lot, but it took 15 minutes to hotglue them haphazardly into my mask (pictures attached) and they worked perfectly; it’s no hassle!Very affordable for what they can achieve!

This lens is thin but flexible. They are half the thickness of regular LED eye props. the wires are so thin that they broke while I was positioning the lights on my Star-Lord helmet. Do not let the light hang or else it will snap easily. Quick tip, after opening this item, put hot glue on the wires near the lens to prevent it from moving which may cause it to snap. Soldering these wires to the LED is a very tedious job as it is so small and can burn easily. The lens is also easy to smudge and difficult to wipe off. Be careful about touching them with unclean hands. Still worked for my project but could be better for the price I paid.

I had to buy two sets. The first set had an LED that fell off the lense. I tried taping and gluing it back on but that didn't help much. The same LED was dim after that. The second set I ordered, I made sure I didn't peel the entire backing tape off of the lease. I cut most of it off but left some on the ends to told the LED in place. An LED still came loose but I was able to crazy glue it back on and the backing tape held it in place. I was able to see out of the lenses when they were on and off for the costume contest but don't try walking around with them on all night.

I bought the circular ones. The wires are very delicate and they broke/disconnected while I was taking the films off which is unfortunate. Otherwise they would have looked really good. I can't really give a rating for visibility and how long it lasts.

The LED is a bit bright, but is perfect for daytime and well lit use. A brightness control built in would make these perfect.You can see through them surprisingly well, it’s a bit like looking through a window screen, but colored