Dortech Metolux Metoset Concrete Repair Resin - Grey (480g) for Repairing Cracks and Sealing Joints, Strong Mortar Repair Ready to Use Cement Filler Suitable for Indoor & Outdoor use

What a brilliant product. Used to fill cracks in walls and pin bolts in to concrete.Easy to use, just make sure you do a lot of filling in one go as it sets super quick and will dry up in a part used tube

I am currently working on my front windows which consist of Victorian frames set in sandstone. Modern double glazing units have then been installed into the ancient frames. The gap between the wooden frames and stone is failing so I raked it out and looked for a modern stone filler. This stuff is amazing. It consists of two separate ingredients held in plastic bags within the tubes and the nozzle has a mixing spiral included. It pumps in very easily, 'goes off' in about 5 minutes and is extremely hard and stable. I have bought 6 tubes and am using it for a variety of repairs. Highly recommended.

I had cracks in wall render, widened these with an angle grinder, ready for filling.This product is a two pack epoxy type product that mixes as it comes out and feels a little flexible and not cement as imagined. It does go off quickly - be warned.You need to fill crack, use a spatula to press in and I found a paint brush dipped in water helped even everything out. Did the job well, but you need to be quick

After doing some research on the best product to repair cracks in render, I came across this product. It seemed ideal as it sets hard, is water resistant and is not flexible like other solutions.I was a little nervous about the working time of 10 minutes but it was really no issue and I had plenty of time to apply. The overall finish was excellent. I was able to rub down the surface after it had begun to harden making it invisible once painted. The finish was much better than expected and that I have seen on other repair jobs on other properties.Main pros:- hard, solid finish- completely paintable- fills deep and wide cracks- screw the lid on to use another time and comes with two nozzles- hardens quickly- do the job well once to last for years kind of feelingCons:- can’t leave more than 10 minutes at a time otherwise it will harden in the nozzleWill 100% use it again even though it might be considered a bit pricey. In my opinion it is totally worth it for a solution that will hold for years to come.

Hold as hell. The best helper around the house.

A little expensive but worth every penny. This thing is so easy to use and drys up rock solid like concrete. Perfect for repairing the exterior render cracks

Brilliant for repair of slabs

This is a good product for filling cracks in rendered properties but it isn't a straightforward product in use.I used this with a powered sealer gun. The consistency is very thick and a powered gun makes application easier. Each tube comes with 2 nozzles that are already the correct size for application.Prior to application I used an angle grinder to cut out the crack to a consistent width and to take the render back to the brickwork along the full length of the crack, approximately 3 meters long and around 1cm wide.I've tube just managed the 3m x 1cm crack. Before use, squeeze out a small amount to ensure the contents mare mixed consistently.The worst thing about this product were that, having injected sealer into the crack, by the time I had finished (about 10 minutes), the product had set to a point that it was unworkable. It appears to have filled well but I would have used a filler knife to ensure the weaker was pressed into the crack but this wasn't possible as it has already set beyond a workable point.This is a good product that I would recommend but, before use, watch some videos on its application.