XINGYHENG 60Pcs 1.0mm 2P 3P 4P 5P Connecting Plug Terminal Connector Wire Cable for Light Strip 5.9’’ Compatible with JST SH

These LEDs are prewired with a resistor so a 9v-12v source can be used. My issue is they use really stiff large wires. No need for this with a low current led. Makes hobby useIn small places impossible.

I needed a special plug for the new battery of my SENA TUBE motorcycle camera, and was having trouble finding the correct plug.I ordered this 60 piece plug kit. It came promptly, and the 3 PIN PLUG was exactly what I needed. I am very happy, found what I had been searching for ! If you need a new plug for your SENA TUBE battery, this is the exact one you need. Note that you need the 3 PIN plug !!!ALSO BE VERY CAREFUL because the new plug is WIRED OPPOSITE to the sena original plug. You must connect the battery BLACK wire to the new plug RED wire, and the battery RED wire to the new plug YELLOW wire ! The new plug middle wire (black one) is not used by you and should be cut off.Please see the two photos, first one with original battery attached to the camera.The second photo is a close-up with the original SENA plug on the left, and the new plug on the right. Please note very carefully the opposite wiring on the new plug.Works perfectly to change batteries on your SENA TUBE helmet cam .

So Far so good.

Using them to connect to the i2c port on a mkr 1010.

If you solider and work with small motors or electronics there perfect