BUCKLOS 26/27.5/29” Mountain Bike Rigid Forks, 1-1/8” Straight MTB Rigid Fork Disc Brake, Superlight Aluminum Alloy Bicycle Rigid Fork fit BMX MTB Road Bike

Upgraded the fork from my road/gravel project bike. Here are my finding. Fork looks great. Welds look great and design.I liked the extra length(height) crown to axle and offset of the fork. Gave my bike more capabilities for downhill segments and in offset increased trail for more control. I toe used to hit my wheel(typical in road bikes) now the wheel is loved forward by about two inches. My foot don't touch now.I did read a comment about Bondo filler and i believe it to be grazing, a metal filler, which is common in bike joints. Now I'm not going to sand off my fork to see if mine had any of it, but I'm sure it's fine. It's a budget fork that improves ride quality, it's solid strong, since i just took it on a 1k ft descend trail ride with rocky sections. Brakes lined up just right and QR axles sit just right. I also like how the there is a wide base at the race crown. Helps sit better with more support against the lower headset. Now this fork is good for commuters and those who cruise trails. Probably not for shredding the trails. Happy ridings.Update: 400miles of trail and trail. Still going strong.

I used these forks to replace the low quality and heavy suspension forks on my girlfriends bicycle. They're well made, strong, and light. Using these forks cut four pounds from the front of her bike. Her bike has 27.5 wheels but I got the forks for a 29 so the length was very close to the original forks.

Fork is light and seems fairly well built with decent looking welds. The problems are as follows.1. Tapered wall thickness on the steering tube makes it hard to cut down and install a star nut. No star nut was included either.2. Brake mounts do not really allow my sram brakes to center properly on the rotor. Fully adjusted over they barely work and probably will be a problem with new pads.3. The drop outs angling back make it impossible to remove my wheel without taking the caliper off. This is a big problem for both transport and changing a tube.So after all the the fork does work and rides decent but the problems are very inconvenient.

Fork is made well and is light. Just check the dimensions of it and confirm it will work with your bike’s geometry.

This is a one size fork, I didn't know that, it's not suitable for 26" wheels but is sold for 26" wheels, see pics. I'm fine with the quality

Needed a 9mm QR disc fork, this will work just fine to resurrect a older mountain bike and make it usable

Purchased this fork for a bike build project I'm in the middle of for my wife. Received the fork 2 days ago and started sanding it down to remove the stickers (impossible to peel or scrape off) and prep for painting. Luckily I discovered this fork has significant filler/bondo in the top third. Quality control and customer safety do not seem to be of concern for this manufacturer.Caveat Emptor (Buyer Beware)

Fantastic fork ,very sturdy very lightweight great finish and looks perfect .I used this to replace a cheap mountain bike fork that weighs a ton and since I don’t do any mountain riding this was perfect . I wished I had done this earlier