To Wind a CordPlease fold the cord to half and then place its bend to the hook inside the winder.Cord will be winded after you gently pull it.To Unwind a CordTake the two ends of the cord and pull it up. Afterwards you may remove the cord from winder easily. There is a trigger under the hook which automaticallylocks the winder so that cord will not be winded when you pull it up. Note1.The recommended diameter of the cord is between 2mm and 3.5mm with length shorter than 1.2m (about 4ft). Thinner cords might be damaged because of the pull force; while longer cords cannot be fully winded by the winder.2.The winder cannot be used for headphone with in-line remote on its cord.3.The winder cannot be used for the cords whose end(s) is (are) too small, for instance, Type C Male.4.You may change the elasticity by adjusting mechanism inside winder.******Increase elasticity******Push the hook at its back. The more you push it, the more elasticity it will get. Please make sure your cord can shoulder the elasticity.******Reduce elasticity******There is a small trigger under the hook. You may reduce elasticity by pressing this trigger.5.Make sure you will pull the cord up when unwind it, otherwise, the hook might not work properly and stop you removing the cord from winder. If it happens, please just press (stop) the hook with finger and it will recover.6.Do not hand over the winder to kids.7.Please judge if your cords adapt to the winder before you use it. Neither the seller nor manufacturer will take the responsibility of property loss caused by the use of cord winder.
Trustpilot
2 months ago
1 month ago
