Generator Cover Waterproof 32 x 24 x 24 inch, Heavy Duty Thicken 600D Polyester Universal Generator Cover for Portable Generators 5000-10000 Watt, Black

Exactly what I wanted. Good quality but not overpriced. Measured generator before ordering - great fit.

This fit perfect with our Predator 5000. We purchased this cover for several reasons, it is very heavy duty and waterproof, and has a flap in the back with Velcro to hold it open for the exhaust pipe, which comes in handy when we go camping in rainy weather and snow. We have several generators and over the years purchased many generator covers, mostly flimsy and not good in bad weather conditions. This is the best we have found and at a great price.

Let me start by saying that my main intention for buying this was to cover my DuroMax XP13000HX generator, which is stored in the garage. I just wanted a cover to keep the dust and debris off it. For that purpose, it'll be fine. It fits just about right. Not too loose, but loose enough you can pull it over easily (with the zippers down) and it will cover the wheels also. The price was decent and probably fits a little better than, say, a barbecue grill cover (though you may want to investigate going that route).I'm knocking 1 star off due to that fact it states that this cover can be used while the generator is running. While that may be true...if the generator is located in an area that has absolutely no wind. There are no provisions on the cover to tie it to the frame. It has 2 sets of elastic straps on each of the 4 sides at the top, but those are intended to hold the sides after you roll them up. My generator requires 3 side flaps to be open while it's running. The long, back side where the muffler is located, and both short end sides, to allow air into the engine (to cool itself) and air into the vents of the generator (to cool itself). The long, front side has the control panel and receptacles, and could be left down, but without anything securing it, it wouldn't do much good.Now that leaves the top. The top is an individual cover that secures to the main cover with velcro. All fine and dandy, right? Not really. The inside perimeter of the top has velcro attached all the way around. So far, so good. The main body only has 3 inch strips sewn to it....right where the aforementioned elastic straps are, which hang down right in the way. Hmm...what a clever design. And since the main body has so little velcro, you can't roll the sides up and still attach the top to the velcro...the roll actually blocks, buries, hides, whatever you wanna call it, the only velcro to attach the top to. Ingenious! All this makes the fact that the top can come off individually pretty much worthless. At that point it's easier just to remove the entire cover. Which is what I plan to do when using the generator.When I use my genny, it's because I've lost power. Funny thing is, when I lose power, it's typically because of a storm. Been here 14 years and can't remember 1 time that a storm didn't also come with a lot of wind. Maybe it's just me, but I can't see this cover surviving on a running generator...that is unless there's absolutely no wind.So for a basic dust cover while in storage, it's fine. An in-use cover? Not so much. Your mileage may vary.

Bought as a father's day gift. Fits my father's 4375 predator generator perfectly. Very heavy canvas type fabric with liner on inside. I also have one for mine and it's been used for several years and is holding up nicely, keeps the dust and dirt off of the generator.

Good cover, thick material. 2nd one I’ve bought.

It was delivered in a timely fashion and fits perfectly!

Excellent purchase!

The cover was perfect no problem with fit God quality Would buy again