Litever90 Degrees Corner Connectors, ONLY for Litever Slim V Shape LED Strip Aluminum Channels, Screws Included, LL-016-90D

The connectors and corner pieces fit beautifully with the aluminum channels for the Hon products that I have. The manufacturer states that they are only for the Litever products (which is quite reasonable), but they both specify the same dimensions. Turns out that the tolerances on both products are good, and they do fit together.My only issue is that I need some of the corner pieces in the reverse configuration. (I want lights facing inwards on an inside corner) but they only manufacturer and offer the other way currently.

these went up fairly smooth, i would make one recommendation for inverted 90 Degree Corner Connectors, the corners are great for going around the rim of the house but took some effort to for 90 degree corners that went opposite direction. You can make it work but would had been much smoother if they actually had the opposite 90 degree connectors as well. Thus the only reason I didn't give it 5 stars on install.

I just completed a number of indoor jobs using these with the V-Channel racks with diffuser. These come with corners and supporting brackets (mid-channel). My advise, throw out the mid-channel supporters. They make the set up look like crap.The corner pieces...I like them and will share a best practice. Before installing them in your corners (which is the first part of the job) take a razor and splice the tops so when you need to run lights through them it’s WAY easier than feeding an entire string and its less wear and tear on the lights. I dont recommend using a saw or dremmel, instead use a razor (see pictures). You’ll have to pry the corner open and feed in the light through and it takes some good finger strength, I did this with several of them and never broke one, they are really sturdy.Once you active the lights you cannot see the cut because you used a blade.

Plastic seems minimalist or thin, for the corners that is ok. However the angled pieces used for mounting mid length on the channel are worthless, fortunately I have metal ones to use instead. As for the corner pieces themselves, they will serve their purpose and save me the time and aggravation of 3D printing something similar

I bought these in-case I needed more connectors along with the ones that came with the main product.Once installed, I can't even notice the connectors, other than the 90-degree corners.I actually used these instead of the ones that came with the raceway. The ones that come with only have one screw hole. With the way that I have to install these, there is no way that I can install the connector by itself.These, as they have two holes, I can have the connector on the raceway and am able to screw it in with no real hassle.One thing I would ask for was, would be 90-degree corners without the part that curves around the side that is supposed to face me. With the LEDs that I used, it was not possible to insert them through, I had to cut that part out myself.I'm not docking any points for that though off of this review as the finished installation looks amazing.I would buy this product again if I ever did a similar project.