Hellwig 7254 Solid, Heat Treated Chromoly, 1-1/2" Rear Sway Bar

Waited to post this review until we have several months with this product. Our View had stock suspension and was rolling and bucking over every swale and bump in the road. The Hellwig has made such a huge difference in smoothing out our ride. I contacted Hellwig directly and all their rear sway bars were on back order at the time. So I checked out Amazon. Same price, same product - (I called hellwig to verify) This takes time, some elbow grease and an extra hand at times, a DIY person will have little to no problems. The Hellwig company has multiple videos to help you navigate this process. Highly recommend. This is a fairly common modification to these campers as the stock sway bar is just too light. You will be amazed at the difference between the two.

When my 2016 Sprinter 3500 RV with 70K + miles lost a sway bar bracket I contacted customer service to get a replacement. I was fully expecting to pay for the kit as it was not an equipment failure.Hellwig sent me a full bracket up-graded kit at no charge. Included both sides.I have up-graded to Hellwig sway bars on all my RV's.

I installed this on a 2018 Winnebago Era 170A, which is on a Sprinter 3500 chassis. The result was amazing. It cut down on the swaying so much that it has made the motorhome a real pleasure to drive. Whereas I used to go into turns a bit white-knuckled, I now go in with the confidence that it will be stable all the way through.I think this is a "must have" replacement for the stock sway bar. It makes no sense to me why the factory doesn't use this spec of sway bar as it has no down-side , only upside.

Easy install about 30 min. Installed on 2010 Itasca Reyo, on 2009 Dodge Sprinter 3500 dually 2WD. Have not upgraded shocks yet but after installing took for test drive and what a huge difference. The difference was noticeable immediately, I backed out of driveway where previously it would rock violently going less than 5 mph and now it feels almost like backing my truck down the driveway. Also took it through the gas station where similar I use to have to drive so slow paint could dry just to avoid whiplash and again it was like driving my truck. I only wish I did this 10 years ago.

Straight forward installation, and good looking!My RV suspension is greatly improved. I am eager to test it out on Hwy 1 tomorrow.

As describedFit was perfectPacked well

This product is great, quite an improvement. Unfortunately, it did not come with the parts that it shows for the product that I ordered. It was missing the castings, and only two washers were supplied whose primary purpose were for spacers in the end links brackets I do not see where this was mentioned, when making the initial purchase. That said the directions did clearly stay to use the factory castings. The directions also showed justified items to be used; sway bar, the two buses, the two washers silicone and Loctite. The instructions are clear and the installation went well.The rating would've been five stars. In fact I received what was advertised. Reused parts on vehicle to complement as per instruction manual. Huge improvement.

So far, so good.We have a Winnebago View and this bar does noticeably reduce the sway and rocking.We still get some 'push' from the wake off of semis that are passing us, as well as from crosswinds though.Rocking when exiting gas stations and parking lots is reduced but definitely still present.In short, a worthwhile mod but don't expect miracles.We have maybe 20,000 miles on the rig with the Hellwig. I was just under it the other day and all hardware is tight and the brackets look good. A while back, some people reported problems with brackets breaking and/or bolts shearing off. That seems to have been resolved.