Premium 20Pcs 608rs Bearings Skateboard Bearings Chrome Steel Bearing Longboard Bearings (8x22x7mm) Double Rubber Sealed Deep Groove Bearing

The media could not be loaded. Initial thought was they were too tight. If you don’t mind a little grease on your hands soak them in some sort of oil/lubricant overnight, then dry off excess with a rag. I used pb blast and was as smooth and fast as higher costing bearings. Well worth it for some roller blading to keep up with my kids at the rink

Best bulk bearings I've found on Amazon. They might cost a little bit more, but they have good tolerances and run smoothly. Plus, they are freaking green dude... Like... Just buy them already. 😛If they see a lot of use, you might want to pull out one of the rubber seals and lube em. Factory pack is basically just rust prevention. Come in lil plastic sleeves and packaged nicely. Yo did I mention they're green? 💚

I used these with a set of aggressive inline wheels and they absolutely get the job done. I cleaned my bearings in alcohol upon getting them (take one side of the cover off with a set of tweezers or angled tweezers with metal tips) then I put a good amount of speed oil inside and slapped the covers back on then popped them in my wheels. For aggressive inline I used DEAD size 58mm x88a and my wheels spin pretty well with minimal effort. I recommend these if you're looking for replacement bearings but if you want top notch skate bearings go for bones or swiss bearings either super reds or super Swiss for more speed.

They work great for out extra roller skating wheels. Easy to install and smooth rolling.

As long as you keep them lubed with some speed creme and keep them dry they perform quite well. I use them on my girls sector 9's and its make wheels looks good. I lube them regularly. amazing value if you keep them lubed and dry. lube them before using too, they are little dry

I used them solely for 3d printed projects. They seem to suffice so far for load bearing applications but do not seem to spin freely for say a fidget spinner.

These are just as you would expect. Great price and well built.People are complaining about them not rotating easily/smoothly. These are listed for skateboards and the grease they use is thick.If you need them to spin faster for lower weight mechanical action then you may need to remove the existing grease and use a lithium or some other thinner type.

Over a decade into owning my 5200 the blade bearings finally gave up. Vitamix specific bearings seem to be $45-75 depending on where you get them and you only get the two bearings for replacement, no spares. Exact replacement, fit like a glove and turn a bit more smoothly than the bearings on the Vitamix replacement blade I purchased a few months ago. Hopefully these last as long, but if they don't I have spares now!