CarBoleMicro Electric Gasoline Fuel Pump Universal 5/16 inch Inlet and Outlet 12V 1-2A 35GPH 4-7 P.S.I. Operating Fuel Pressure

Mounted to a piece of wood and used as a transfer pump for a gas tank. Worked well pumping the fuel as long as the pickup hose didn’t go too high above the tank. I was also able to pump the water out from the bottom of the tank with this pump.

Great quality and very durable.

Working great thanks

Failed after pumping only 7 gallons of gas, siphoning out of a gas tank. No pressure load and it still pumped very slowly when it was working, before it died.

The media could not be loaded. @weaverstonehousefarm on YouTubePressure is 7psi on my gauge in the video.Even at full throttle on my IH 444 tractor it works fine. The bolt holes line up with the factory pump holes.It has a 5/16” smooth barb outlet connection for a rubber fuel line. It’s can’t be removed or replaced.I wish that outlet was threaded. There are other models with a threaded outlet.Inlet is threaded. Possibly 1/4” FPT.I got tired of every 3-4 years replacing the $60-80 dollar pump from NAPA.For the twenty something dollars it will work and looks similar.I tried this higher pressure pump as the 2-3 psi pumps would barely put out 2psi.Wiring was simple 12+volt DC positive and the ground wire to the bolt for the base.It comes with mounting bolts.We make hay and run our equipment in the worst and hottest parts of the summer so it’s expected that and electric fuel pump w/o any external cooling will eventually fail for us. It gets so hot sometimes when making hay the fuel will boil in the tank.

The media could not be loaded. Saw a YouTube using this as part of Filtering Water from a Boat Fuel tank.Combined it with a Water filter, Cutting Board and some 3/8" hose to filter 30 Gal tank on Party Barge.Worked well, about 12 oz of water in an hour.

Does everything I want for my Holley 650 4 barrel carburetor on my truck -1975 IH 1600--------------------I have been asked a lot of questions by people from Amazon about this fuel pump.The biggest question I get - will it work on a particular model. Sometimes I can answer that question, while others are not sure. When it comes down to carburetors each has a certain PSI for fuel pressure rating. These need to be match. If a carb is rated @ 6psi then the fuel pump should be @ 5 PSI or a little less . If you get too much PSI, the float in the carb WILL NOT shut off. This will cause the carb to flood fuel everywhere in & on the engine. Not enough PSI might cause low fuel delivery. The other item is GPH {gallons per minute}, in most cases this is not important issue, unless you got a rocket vehicle that needs massive fuel delivery. Also I have been asked about the mounting positions, I always try to mount it feet down and also close to the fuel supply {tank} as possible. A general rule to any type pump, it can push liquid farther than it can pull it {from tank}. Hope this helps.

Order this awhile ago and just now got to install. This little pump works well, unfortunately it has a hairline crack in the plastic on the inlet side.Unfortunately I have to buy another one and re install tomorrow, this time I'm going with the metal one. Really wish this would have worked out.