Kingston BrassCC471 Vintage Double Offset Bath Supply, 25-Inch, Polished Chrome

Exactly what we needed. Fit pefect and nice finish

Used to replace supply lines to a 1920's cast iron clawfoot tub when replacing the tub faucet\shower. Lined up perfectly and look great. Of course you have to cut them to the correct length - that's the only stressful part. Like that they come with all the required washers and nuts, and even decorative flanges even though I didn't use them because I added shut-offs.

Way to flimsy for practical use. Could be used as a straw for your favorite beverage:)

I thought they were grab bars

Very happy to have found these. Out local plumbing folks were useless and said there was no way to match the "specialty" connectors on our clawfoot tub faucets. Took me 10 minutes on Amazon to find this and order it. And hey, it fit. Looks great, too.

First off these work and the finish was good. However a customer bought a new Kingston brass faucet with matching drain and faucet supply's with supply stops. The supply lines needed to be bent and even using a ridgid tubing bender this proved difficult. The two supply's needed three 45° bends to align with the supply valve. The first one worked but the bends did not look like they should with the temper of other supplies I had used in the past. The second kinked on the first bend which led me to order another set of supplies. If the water lines would originally been roughed in at the correct location years ago this would not have been a problem. Luckily the third supply bent without any major issues but if they had a better temper to allow them to be bent it would have made the job much easier and cheaper.

Is it to install and it looked beautiful when they were done. Would definitely buy again.

nice looking, no issues !!