EasyPro Pond Products CF18E Eco-Series 18” Waterfall Spillway is Ideal for Just-A-Falls Water Features. Connect Liner Without Tools. 2-2” Installed Spinweld Inlets. Up to 3400 to 4500 GPH Flow

I purchased the spillway to replace my current one; love that fact that all i had to do was screw the liner into the spillway no tools needed, however, I did not realize that the intake was 2" tubing, so I had to return it, I needed one with an intake 1 1/2"

The media could not be loaded. Works well. I have mine free standing and built ledgestone around it. I did not attach the liner to it but you can with the way its made. Nice quality.

I recently rebuilt the waterfall for my koi pond and purchased this for that project. I liked the 2" fittings provided on each end of the spillway as it allowed me to run the input from my recirculating pump into one side and the fresh water feed from my well in the other. This allows me to circulate water through the filter and into the waterfall all the time and add water from the well when needed. I can't give it 4 stars however because the top lip is not strong enough to support rock and so finding a way to properly cap the waterfall has been a challenge. The vendor offers a faux spillway rock but a cap rock designed for the spillway would be a great addition.

Seems to be of good quality.I have installed it but have not turned on the system, since the huge 30 ft waterfall is still a on-going project

This waterfall box was just what I was looking for. There is no filtration, just a water feature. The water tumbles out in a bubbly jumble, giving maximum water sounds and maximum aeration. Very easy to install.

Functional but warpedI have 2 both very missed shapped

This was just what I needed. I already had one bio-filter waterfall and I wanted to expand the pond. This unit didn't need to filter the water, but was needed to ensure good flow throughout the pond. Also, didn't want to add another pump, so used a splitter and a shutoff valve to the unit to balance the flows. This spillway is solidly built, and everything you need to plumb it is included. I made sure that both falls were the same height to avoid potential flow imbalances.

The spillway has a bar that is supposed to hold the liner in place under the lip of the spillway. The plastic pieces that hold the bar in place are loose and cannot be tightened due to the type of screw that was used. This makes it difficult to attach the liner to the spillway and have it stay in place. Additionally, water leaks through the screw holes and, if the liner comes loose, will flow behind the liner and your system will quickly loose water.I found this out because my system was leaking water and when I checked the spillway I found that the vibration of the water over the lip had caused the liner to come loose and a lot of water was leaking through the screw holes. In order to fix this I applied some 4" wide under water Gorilla tape to the spillway (over the top of the screws), and no more leaks.For the prices, this is one very poorly engineered piece of plastic. If you buy this, I would recommend drilling out the existing screws and using screws that you can actually tighten. Then cover the screws with an under water rated tape.