APT, UHMW (Ultra-high Molecular Weight) Polyethylene Tape, Resists Abrasion, Impact, for Surface Protection and Friction and Noise Reduction for Lining Sliding Surfaces. (1" x 18Yds, 5 Mil UHMW)

The item is as advertised.I used it to remove side to side play with the upgraded miter gauge I'm using with the DeWalt DWE7941RS job site table saw.Installed a few pieces on the miter bar and 4 pieces underneath the miter gauge. The pieces placed underneath were to eliminate the drag across the finish to the table top by DeWalt (non-slip but rough).The miter gauge moves and slides like it's on a proper stand alone table saw.Great product -Easy to use -Easy to cut to size -

we have a pull out pantry beside our fridge and I tried adding felt pads to it so it wouldn't drag on the wall but the texture on the wall was striping the felt so I add this tape over top of the felt pad and now it glides perfectly

I got an antique chest of drawers and the drawers were really hard to open and close. After years of opening and closing, wood on wood, they just dragged. This tape solved the problem. They provide a smooth surface to glide on.

I used this to replace what was on my cut off sled and Inca miter gauge, both used on my table saw. This is superior to what was used before. Excellent adhesion and provides a low friction to both my tools. Highly recommend

I purchased the tape to tighten up the clearance between my table saw fence and a shop made wooden jig that slides on the fence. The tape improved the tolerance as well as providing a very frictionless movement of the jig.

Used this to line the bottom edge of a slide out desk cover on a desk made from an old pump organ. The polyurethane top was sticking to the slide surface. Putting an unseen strip of your tape on the bottom keeps it free.

Adhered well to the bottom of a new miter Guage to keep additional wear from occurring. Easy to cut and good amount for the money.

Nice product, exactly what I needed.

I bought this to use on a number of projects in a campervan conversion and it's brilliant. So far, I've used it on sliding cupboard doors and runners for drawers at floor level and it's worked like a dream. Next job is the folding bed/settee mechanism (but I haven't finished building it yet). It's lighter and takes up much less space than conventional drawer runners, so, basically, anywhere there will be wood on wood movement, a strip of this on each side and the job's done.

I used this on my car to stop the rubber round the windows from squeaking and crunching against the frame. It worked brilliantly for about 2 weeks and not sure if weather related as in worn away not as effect as got dirtier or just not the highest quality as cheap compared to other same tapes but the squeaks are back in full force ☹ ive got some left so going try it again though and see.

I have been making a variety of jigs for routing and woodworking and have found this gives just that extra bit of slip to make a wooden piece work better.

This is so good I would say it glides like a slug on ice perfecy for 99% of items that you dont want any friction to be a problem One thing is that its not cheap.

I used this tape on some wooden furniture. One strip along the runner and the drawer sides beautifully.