PLATT Bicycle Bar End Plugs Aluminum Bike Handlebar Cap for Road Bike Mountain Bike BMX

Looks and fits great

Colourful and look good, easy fit too.And with the ends made of metal they're very robust.I really like these and good value too.

Well built. I took care not to over tighten them and they seem to be working fine. Says 1.5Nm on the item itself and this equates to light pressure with the Allan key. I don't have a torque limiter, but tested them before insertion and got a visual idea of how much they would need to be tightened to grip the inside of the handlebar. Can't pull them out with fingernails so I think I have less chance of losing them than the stock plastic 'bungs' that came on the bike.4 stars as I think the diameter of the end cap could be a few mm wider, (stock plastic bungs are about 4mm wider overal)l, which would hold the bar tape better and also they are much heavier than bungs at 12g each. 24g total. I know that's not much, but plastic plugs were about 1g and these weights all add up on a bike ;)Need to test them for a while as they have just been installed today but will update of they fall out!

Fitted my bike perfectly, quick delivery.

Lost the standard plastic one I had on my Mountain Bike and went for a cheap replacement. Very easy to install but be careful as they can be prone to be over-tightened.They fit flush and snug and look really nice, the fact that they’re metal as well gives them a much better look than the factory plastic ones. Well worth the money.

Lots of choice on here but chose theseDon’t seem cheap and crapHas a bit of weight to then so hopefully will lastFitted perfect to replace the usual butt ends

Used a torque screwdriver to fit these to the recommended torque, but the plastic wedge still twisted and deformed on one of the two. They are secure and look good once on the bike.

Only realized when I'd fitted the bearings that the compression ring was missing.