APIELE 19mm 0.74" 12V Latching White Angel Eye Halo Ring LED Metal Push Button Toggle Car Switch 1NO1NC SPDT with Wire Socket Plug

I used this switch to replace my NTC designs pushbutton switch. It just has to be wires into the ignition position as normally open, and also to the 12 volt 60 Volt DC to 12 Volt DC converter power to light up the 12 v LED when power is on. The switch has it's own internal bias resistor, no need for an external one, makes wiring much easier than other switches which don't have the current limiting bias resistor.WDIT: Bought two, as a spare

Good quality switch and easy installs instructions. Installed it to stop the draw or constant power but my battery still dies so I got to figure out the problem. But overall good product

I have mine wired where when my device is activated the light is on and when I push it in the light goes off and the device is off.I use this for my four-wheel drive actuator to turn it off and on instead of having to shift it manually on the floor. Works great.Best invention I ever came up with!!

I wish I could rate these better, but I can not. The rubber washer that makes them water tight is poor quality. Anything over higher tightening will cause them to squeeze out the side and not seat properly, making them non-water proof. Beef up the rubber ring, and I will give you a better score.

Super satisfying click. wiring diagram is clear for multiple different wire concepts. All around great.

I bought this to control the halos on my headlights. I have halos that are red and the switch turns on the second input to make them amber. I was able to wire this so that when it is off the red halo lights just like the headlight halo. When I turn it on, the halo goes out and the headlight halo is amber (which is legal). Now I have an obvious indicator in the jeep if the halos are red (not street legal) to keel me out of trouble. This switch comes with a wiring map to help with 4 different wiring options for most applications. I would recommend this switch.

Quality switch with nice detachable wire harness

Hooked up my LEDs on my desk and my camera and stream light to these. Worked like a dream and look great too!

Latching mechanism is smooth.

Smart looking swich complete with wiring socket

tres beau bouton-poussoir illuminé , très contente.

for 4-way flashers on e-bike

It's a nice button does what it says it's supposed to do, but not as solid as I hoped. The stainless steel is just thin casing, and the button is kind of small so when you press it your finger pushes up against the rim which is kind of sharp not like it cuts you it's just uncomfortable for people with big fingers.