Krator Motorcycle Handlebar 7/8" (2.2 cm) Universal Low-Rise Handlebars Compatible with Cafe Racer, Bobber Motocross, Dirt Bikes, Pit Bikes, ATVs, E-Bikes & Mini Bikes Euro-Style Polished Handlebar

Installed on a 2006 Ninja 650 without fairings. These bars are sturdy and being wide and low provide a more comfortable wrist angle than factory bars. As others have mentioned, you have to drill out the ends to use bar end mirrors. No big deal. I’m sure they would bend if you dropped the bike at any speed but just don’t crash and you won’t have to worry about it. They are aluminum so it’s easy to drill out for bar end accessories and the control pins. I recommend them.

I've bought a few sets of bars at a similar price range to these and they're always paper thin painted aluminum with no knurling that chip super easy. Dimensions are always off and they need to be sanded to fit the throttle tube. The finish on these is really high quality. One thing to be aware of, they're THICK. So make sure your bar end accessories have a smaller diameter than standard steel bars. Luckily my mirrors came with a smaller diameter attachment.

Got this bar for a custom build mini bike and it works excellent for that! Not sure I'd trust them to be sturdy enough for a larger or off road bike. For the money, it was a gamble worth taking. Nice black finish and easy to install into 7/8 riser. Very good stability and balance for a Mini bike. Great value for what I needed it for

These are actually great handlebars. The position is much more comfortable than the bent stock bars on my rebel 250. But the only downsides I have found is that it is very lightweight, so vibration to the handlebars is increased. And the inner diameter of the bars WILL NOT fit bar end mirrors. I made it work with some Macgyver-ing but the average bear is not getting bar end mirrors in these bars. Or any bar end accessories for that matter.

Look nice, fit well, just be advised these bars are very narrow. If that’s what you’re going for they’re great. Just wide enough to fit typical handlebar controls, gives a clean minimalist look. Also thick wall aluminum, will not work with bar end accessories so don’t buy these if you’re hoping to install bar end mirrors or vibration dampeners, won’t work without modification.

I so very happy with article excellent shopping

The handlebar came very quickly considering it was an international shipment (Canada to US). The bars had a nice gloss finish to them and fit my bike and controls perfectly. Wish the middle section was wider so I could fit my phone mount but that is a minor gripe and won’t deduct any stars. Also wish the ends were threaded so I could fit bar end sliders. For the price I paid, I’m extremely happy. Let’s see how they hold up!

The bars looks great and are really light. The only thing is that since they are aluminum they have thicker inner walls. If you plan on adding any bar end accessories like mirrors or signals you will have to drill out the ends to make them fit. Also the bars DO NOT come pre drilled, so you will also have to make all the holes. Once you wire everything up it was VERY difficult to route all the wires through the bars to the bottom, might consider just zip tying them on the outside.

Excellent for the price but if you install end mirrors you will have to drill out a bit of the aluminum.

When I ordered these bars I wasn’t sure what to expect until they arrived. I noticed right off the bat that they’ll work fine. I didn’t know if the paint would allow for electrical continuity, but they are designed to do just that.Pictured is my project ‘80 Honda CB650 which I purchased for. Perfect fit for vintage CB’s

great product just a little bit too expensive.

Installed on my cafe racer project, they are exactly the look I wanted, worked with all oem controls

Even better than expected. Was looking at getting similar bars at a shop and they were 4x the price and not as nice. Highly recommend.