YAMATIC Pressure Washer Hose 25 FT 1/4", M22-14mm Females | 3200 PSI, Kink-Resistant Hose With Solid Brass Fittings Replacement For Ryobi Greenworks Troy-Bilt Craftsman

Fit good and works grear

I knew my old hose was not going to last much longer so I started looking around for a replacement. Too expensive in the local big box stores so I started searching online. Then I discovered there are two popular sizes for the fittings, 14mm and 15mm. I went back to the instructions for my Craftsman gas pressure cleaner and determined I need the 14mm size, and I already knew I needed one that would be rated for 3000psi pressure.Unlike some competing products, the description for this particular hose was complete enough for me to see it would be the correct size and was rated for the pressure I needed. And the price was much better than I had seen locally. The reviews on some of the other ones online were not too good; they talked about the hose not lasting for more than one or two cleaning cycles! But the reviews for this one were quite good.And now, I am pleased to add my own positive experience. The hose arrived well within the estimated arrival timeframe. I didn't use it right away, as I intended it as a spare. However two days later, my old hose burst! So it is a lucky thing I ordered this one when I did; all I had to do was disconnect the old hose and replace it with this new one. The fittings were perfect for my pressure washer on both ends. It works great!I like the finish of the outside of the hose as well. The old one had a very "flat" finish, and constant rubbing on the concrete (sidewalk, driveway) being cleaned is what wore the hose down and caused it to be weak in several places, one of which being where it burst. This new hose has a "glossier" finish, which seems to glide across the concrete more easily. Perhaps that finish will wear off and it will become more like the old hose, but for now, it appears to be holding up well.I am pleased to recommend this product!

Great 25 ft. hose, I ordered this to lengthen my existing 25 ft. pressure washer hose , so now I have 50 ft. to work with. It coupled very nicely using a 22mm brass coupling also available on Amazon.

Good product for the price, a little stiff to work with when it's cool out but it gets better when it warms up. I would purchase again.

Purchased to replace original hose on Generac Power Washer. Much easier to deal with when finished and winding up in coil.

Fits my Worx washer perfectly on both ends. Keep in mind that not all Worx washers use the same connections. This does NOT have a QC on one end. The hose is not anymore durable than the original. I used the original enough that it scuffed a hole into it and it sprung a leak. This one will do the same thing if not protected. Concrete abrasion is real. :)

Great

Better than I expected.Would buy again

like the long cord for reaching higher areas.

it does a good job

Excellent. Received it and started using it right away. It’s been 2 days and the outside of the house looks good !

It is perfect just what I wanted

Meets my expectations