Superior 18-1601 Rubber Coil Spring Booster, Small (4)

UPDATE:The wife's car started scraping again, so upon inspection we found that 5 of the 8 had fallen out at some point.We ordered another set. Only this time, I drilled holes through them, ran zip ties through them, and zip tied them to the springs. They shouldn't go anywhere now. I recommend doing the same. See attached pic.Original post:Used these to lift a 2012 civic hybrid that wouldn't get into the garage without scraping under the middle of the car. The spacers lifted it about 1.25", and didn't change the ride quality that much.THESE ARE DESIGNED TO USE 2 PER SPRING, OTHERWISE THERE WILL BE TOO MUCH PRESSURE ON ONE, AND THEY'LL SPLIT (like other people's complaints). If you use them correctly, they work fine. Order 2 sets.

You have to modify these in order to work. You need to drill holes and use zip ties with these. Also make sure you use Lithium Grease on these so they stayed lubed and won't wash off. Otherwise it may make some squeaks noise.

I tried this thing to my car and it worked perfectly. However, I only have 2 stars because sometimes when the spring expands when you made a hard turn the rubber slides and touches my axles on my rear. When you drive there’s that squealing sound and it’s super annoying and embarrassing to drive it around when it happened.

I already wrote a review praising these spacers ! ! Well I want to to retract it These spacers broke in 2 after 1 month !! These are not the same spacers we used in the 60's and 70's to lift heavy cars ,like 55-57 Chevys,and 54-54 Fords I put these spacers in a MG Midget and they broke in half !!!!!

I needed to keep my BMW from front wheel scape when switching to 18” snows vs stock 19’s.They DO WORK and did stop the scrape as I only needed about a half inch more clearance...but they will break or just fall out eventually. I still have a few left for next winter.

Needed to reverse a coil spring compressor to spread the spring for installation. Bushing broke in half after a about a week of use. However, before the bushing failed it's result on the handling was remarkable.

I was trying to solve a sagging issue with the front drivers side of my car. I normally drive by myself so that side has become to sag over the years. Install wise - it was straight forward. I used WD-40 to help squeeze it into place.

Working real well for the front coil springs for the last few months, will buy again