PWM Servo Motor Driver IIC Module 16 Channel PWM Outputs 12 Bit Resolution I2C Compatible with Raspberry Pi 5 4 3B+ 3B Zero/Zero W/Zero WH and Jetson Nano

Used this to work servo motors on a 3d printed project. It worked quite well, so I have no complaints.

This board NEEDS the sample file loaded so that all its drivers get setup and configured as need. I was new to driving servos with a 'hat' board - but once you understand its operation, it works flawlessly.

Arrived quick. Untested due to project delay or cancellation. Can't speak to its function but other reviews make this seem to be the best choice.

A good, flexible board useful for powering 9g servos right out of the box. However if you want to control more powerful servos I'd highly recommend a servo break-out board to prevent any voltage spikes from ruining your hardware. Supposedly can connect up to something like 64 boards to a single controller, but board addresses (configured by some small soldering on the board) are only explicitly documented up to 4 boards. Speaking of documentation, this uses the PCA9685 chip, so any libraries for that will work.

it wont fit under any retail/included rpi case, so you'll have to cut it in. it worked reliably, snapped right onto the gpio bus and passed all pins. i used it to drive that 2 servo motor tripod im sure you've seen on amazon. Worked fine for me. You'll need to install the adafuit pwm stuff.

Took couple minutes to install and works great - have made a robot hand already! cost is so low! thank you for making affordable hats.

I tried to use this servo-hat to control 12 servos using RPi. This hat gave me lot of problems. Later, I found out the VIN terminal does not work and my Pi was messed up since all the servos were taking power from RPi.

This is a nice little board. My biggest concern is per the schematic and per my multimeter the output of the buck regulator is connected to pins 2 and 4 on the Pi header. This is bad as either the USB 5V will overdrive the 5V regulator or the 5V regulator will attempt to power the Pi. As a professional electrical engineer, this is a bad design. Generally you want a diode to only accept the highest voltage regulator. So I would be very concerned about this board damaging your Pi or vice versa. It isn't shown on the schematic, but there is a zero ohm resistor that should be removed to prevent back feeding.

Work nice. Had a project requiring servos and it really did the job. I have a raspberry pi 4 and it was the simplest and best upgrade I made (depending on your projects requirements)

El modulo trae unos bornes de alimentación (Vin y GND), supuestamente para alimentar con una fuente externa, sin embargo, estos bornes vienen cortocircuitados con la la alimentación de la Raspberry, por lo que si conectas una fuente externa puedes dañar a la Raspberry. No trae un jumper para quitar esa conexión y poder usar una alimentación externa.