Question 1

What is the fitting type e.g. NPT?

Accepted Answer

For about 30 years my swimming pool filter was trapping air, reducing its filtration efficiency and causing the pool cleaner to move about very slowly. No one can figure out why. There is a product that is supposed to remove this trapped air and according to close to 100% of the reviews it did not work and it allowed a lot of water to escape costing a lot of money on the water monthly bill. When I saw this product listed on Amazon to relieve steam in industrial settings and never mention it to be used in swimming pool filters. Since I installed it on my pool water filter the air trapping problem disappeared once and for all. I wish I knew about this product 30 years ago. It is very well made, easy to take apart and clean. The bottom part is interchangeable depending on the size of the fitting you need, it is offered in ⅛, ¼, ½, ¾, 1 inch sizes. It must be mounted in the vertical position to help the float (also works as a check valve) to work with the gravity. It comes with a nice large size silicone washer to allow you to screw it on or remove it by hand (no tools). I purchased a ¼ inch brass elbow (the size of the fitting on top of my water filter) at Home Depot (see pictures) for about $ 5.00 dollars. Beduan company should advertise it to be used on pool filters because it will increase their sales astronomically.

Question 2

What is physical size?

Accepted Answer

3 inches high 1nch  and a half wide 3/4 thread

Question 3

Does this let air only out or can it let air in also like an admittance valve?

Accepted Answer

it has a float inside that will rise with the water in the pipe. air passes around the float and out the top and then closes off when water pushes the float up.. this bleeds air out of the pipe of the bleeder is a the top of the system. If water were to drain out from lower in the system the float should drop and air should be able to enter from the vent at the top of the bleeder assy.  An air admittance valve is closed off all the time by a spring loaded diaphragm and only opens hen there is sufficient pressure difference such as when you flush a toilet.

Question 4

What is the thread size for the air outlet for the 1/2"  npt one?

Accepted Answer

The threads on the outlet end match the cap and are not standard threads. The OD of the thread is approximately 9/32".Thread type is G thread.

ASIN	B085WRYP2Y
Best Sellers Rank	#41,973 in Industrial & Scientific ( See Top 100 in Industrial & Scientific ) #60 in Float Valves
Brand	beduan
Brand Name	beduan
Connector Type	Threaded
Customer Reviews	4.4 out of 5 stars 310 Reviews
Exterior Finish	Brass
Inlet Connection Size	1 Inches
Inlet Connection Type	Threaded
Manufacturer	Beduan
Manufacturer Part Number	1xy-10560-ven
Material	Brass
Material Type	Brass
Maximum Operating Pressure	150 Pound per Square Inch
Maximum Pressure	150 Pound per Square Inch
Model Number	1xy-10560-ven
Number of Ports	2
Size	1" Male
Thread Size	1 inch
Thread Type	Male
UPC	077063578326
Unit Count	1 Count
Valve Type	Float Valve

Beduan Brass 10500-VE Automatic Float Valve, 1" Male Thread Air Release Valve Air Bleeder Valve Vent Valve

Details

Details

Description

Specifications

Common Questions