Black Stainless Steel Wall Corner Guards 2 x 2 x 48 inch, Pack of 6 L-Shape Metal Wall Corner Protectors 304 Steel Corner Trim with 90-Degree Angle for Wall Protection and Decoration

I use them on all my job sites to make them look more professional and luxury

I installed the black 2×2×48 pair on a shop door frame that takes cart bumps. The 304 stainless looks clean and wipes down easily. Gauge is light (listed 24ga), but once adhered it sits flat and feels secure. One piece arrived a hair tighter than 90 degrees; pressing it in during placement closed the tiny gap.No adhesive is included. I used heavy-duty double-sided tape in a zigzag and held it with painter’s tape for a day, and it hasn’t budged. Edges are sharp out of the box—use the included gloves. For rough corners or heavier abuse, drilling and countersinking for screws or stepping up to a thicker guard may be the better route.

Great protection of drywall corners from wheelchairs.Easy installation and they look sharp.

I was tired of patching and repainting the corner of my wall, so I ordered these corner guards to protect it. They came well-protected with a layer of film to prevent scratches that you peel off after installation. While there is no mounting hardware or adhesive included, I used some 3M 5952 VHB Tape to attach it to the drywall. I noticed that the right angle appears ever so slightly tighter than 90 degrees, so I had to apply extra pressure during installation to make sure it was a secure fit. Using adhesive for mounting was much easier than using screws, anchors, or brackets.I've had these installed for a few weeks and they're holding up well. Functionally, they protect the wall corner from dents, scratches, and scuffs, and visually, they look sleek with a clean brushed metal finish.

I was looking for a good quality and strong corner shield, the corner or edges have more damages and it wasn't looking good. This has covered it completely and it now looks great. This is not heavy or light weight, for its quality and strength it's in a decent weight, we need a really strong glue to hold it. I called the handyman to get it installed, I'm sure most of them can install on their own but being it needs to glued and I need to strip off the old one I needed the help. It comes with the protective adhesive so needs to be carefully removed, the edges are sharp.While install it needs to be pressed firmly to get it completely covered or else there will be a gap where air gets in and the glue will get loosen. My recommendation is why can't it an option to come up with glued instead of getting it separate, that would help. Overall it's great and nice looking.

We pull a cart in and out of the shop man door frequently for projects, and it inevitably bangs against the corners of the doorframe. These stainless corner protectors are doing a great job of keeping the doorframe intact. They were simple to install with some double sided tape that we already had. They look good with the other stainless fittings that we have in the shop. They take the bumps a lot better than the wood did, and should last for as long as the shop stands. They can be a little sharp to handle while you're installing, so wear gloves. After installation that's not an issue.

excellent quality corner guards. great for protecting corners. easy to install. just drill and countersink holes and use screws. great value.

They were not 90 degrees and the flat sides were a bit rounded so it does not lay flat against the surface, means you need a lot of glue (not included) or thick double sided tape to fill that gap. Also the edges on one side were bend. I think they could have prevented that by packaging better before shipping instead of just bubble-wrap in a box.