8-24W LED Driver Large Board with Terminal Plugs, Constant Current 300mA AC 85-265V Output 15-26V External Power Supply Rectifier Transformer for LED Ceiling Light

Works good. Creates a lot of electrical "whining" noise if you load it down to about 1/3 of its max. Other than the noise, it works like it should

I had an led fixture over the bathroom sink from Hamilton beach. It lasted a little over a year and then began flickering before not working except on very low. The other lights had to be off to even see it. I followed the label on the led driver in the unit and selected this as the closest in specs. Spliced it in and we’re back in the light again! Would recommend for similar fixes.

They definitely work in that they will dim your LED lights and signs, but simply plugging them into the dimmer, even at full brightness you will notice a significant dimming versus how bright it would be plugged in directly without the dimmer. So even at full brightness, it is not in fact the full brightness. For the price though, it's still pretty good.

Even though others stated they had issues with these dimmers I decided to try them! YES, they are terrible. Mine only work without rapidly flashing with the control knob all the way up. There would be no need for these dimmer switches if they don’t dim! Take my advice…go with another brand!

They work great, pretty much just plug N play.

Zero instructions on how to set this sensor up. Plugged it in and my light instantly powered on. Waited 5 min and with no motion to the sensor and the light never turns off. You have to make sure the in/out are wired properly. I had to cut and rewire the connections as they were the opposite of the light I was attaching. Product works fine, no instructions and very vaguely mentions they the in/out put have to be specific for the sensor to work properly

used to dime my led neon signs, works good

No instructions. Not much to it, just need to figure the timing and how close or far it senses. But it does work.