ALAVENTE Dual A-pillar Light Brackets For Jeep Wrangler JK 2007-2017 Dual Lower Windshield Hinge Corner Bracket | LED Work Light Mounts Kit

Two things would have made these better. The entire backside of the bracket should have been covered with closed cell foam and not just the part that "touches" the paint. Secondly these brackets could have had a little more bend back towards the windshield to cut down on the vibration of the lights. The current set up pretty much mounts the lights out on a "stiff" diving board. The vibration can be bothersome if you are focused on the lights while driving down the road however you should be paying attention to the road anyways. With all that said I added my own closed cell foam to the rest of the bracket and gave the bracket a slight bend to make contact with the windshield (foam to glass) in order to eliminate the vibration. Pro tip number two is that you will have to run a shorter windshield wiper on the passenger side as well otherwise the wiper will interfere with the bracket. I am running a 13" wiper on that side, the factory size is 15". I was due for new wipers at the time of the install so that wasn't much of a hassle for me. Even with all these little modificatiosn and "additional cost" this bracket was $40 cheaper than the next best alternative on the market.

This matched the holes, but that was all that did. It extended over windshield interfering with wipers, and the curve was wrong. Not sure if i was sent the wrong ones... but we trimmed it, painted and installed. Not sure someone without the tools could use as is, unless what i received was wrong model

Other than the windshield wiper rubbing on the passenger side they are very well made and easy to install. Just replace the wiper with one that is 1" shorter and you'll be happy with this product.

Picked these up for my pod lights and GMRS stubby antenna. First thing I noticed is the components of the brackets are only welded on one side, not really a deal breaker but that kinda surprised me. Second thing is, the lower arm of the bracket sticks out far enough and is close enough to the lower bolt hole, that you can’t actually get a socket in there to drive in the bolt. By raising the lower arm of the bracket about a quarter inch, there would be plenty of room.

Very solid well-built brackets

Works great don’t no why some people cried so much saying it was bad or something like that easy install and looks great and windshield wipers don’t hit it looks awesome can’t wait get my lights and get it all hooked up

Going down the highway, I notice the top light pod that I installed is vibrating from the wind resistance at 65 mph. I wish the back bar was a little bit stiffer. Otherwise great product

Used these for dual Rigid radiance pods and worked great!

Buen material, se ajustó muy bien a mi auto.

Le quedaron perfectas a mi jeep 👌👏 muy buen material

perfect fit

Product is exactly as you would think other than the holes that are pre-drilled for the lights is too big

Great fit. Looks awsome