KitsGuru GY-NEO6MV2 new GPS module NEO6MV2 NEO-6M

Very good productPls note that you need to use 3.5v and place the GPS near windowI ordered it initially but it was faulty. For faulty GPS, the light does not bring.

I have been using this product for the last three months (April 2018 onwards). A very good product.The very first time it took about 10 minutes to lock onto the signal/satellites. Next time onwards thethe device starts receiving the data well under 30 secs. The quality of the data is pretty good as I canplot my routes on the Google maps using this data and usually accurate to about 3 to 4 meters, whichI think is the best one can get. Of course, the data gathered under the tunnels, tree cover, near tallbuildings have their share of inaccuracy and nothing to do with the device. Overall, 95% of the timeI have got good results. I am happy about it. BTW, I am using the device (not with arduino/other mc)but with some other IMU device.

To be fair I bought this item twice over. The first one did not seem to work. I don't think I was configuring it incorrectly as there was very little to be done. Anyhow, I had that returned and the money was refunded in no time. I bought a second one and that works fine. Easy to configure with any Arduino (I use the UNO).

nothing

got a faulty one which was not transmitting data through arduino serial port to serial monitor even though it was connected for more than 2hrs no gps signal from satellite finally i applied for refund.So please connect it to 3.3v VCC and then the module should automatically send some data received from satellite to serial port

I have built various projects with this GPS module and it is very precise and provided you precise location coordinates.But, make sure that you have enough experience before purchasing the same and you know about this module before buying it.

Good product as described. . Satellite locking is good.. plz note that direct connection to RX TX is not recommended , because there is no resistance in this module(some rare board has comes with RX resistor).. use 10K, 4.7k combination just google it. And use 9600 buad rate for software serial(GPS MODULE ) Just power up the module.. wait just a minute for first time sat lock till led flashing.... Nice shipping ..

Initially it was not doing anything. Then after 10 minutes it sprang into life. While connected to arduino use tiny gps plus and serial connect library. And when I checked it was pretty accurate.