XPEL ( xpf0375u100 ) 3 / 8 " x 100 'ドアエッジガード 3/8 Inch x 100 Foot XPF0375U100

透明で二重張りすれば 大概の傷には耐えれます。 ドアエッジなら擦れる場所でもないし 純正や社外のプロテクターの 付いてる感じが嫌で もしも失敗しても 傷ついても 張り替えれば良いし 質感も良い テープと考えたら高いけれど 用途を考えたら安いと思う。

思ってたより薄くて、伸びも適度で施工は楽に出来ました。 目立たなくて、もう１年以上装着してますが、剥がれもなく、ガードも問題無し、 前車の純正品と同等品質です。

ちょっと貼るのにコツがいりますが、何台分あるんだよ！ってぐらいの量ですので、失敗しても気兼ねなく張り直せます。傷防止にはなりますが、衝撃防止にはなりません（当たり前ですが）。もう少し安ければいいんですけどねぇ

Great item. Very discreet and does the job very well. Will buy again

I bought this "XPEL Extra Wide Door Edge Guard" for my new Mercedes' doors. It came as 2 rolls, but even one roll is more than enough for my new car. Very easy to apply and it can accommodate all the curves and angles. I sticked it on the outside first and then slowly rolled to the back one segment after another. The most important thing is not to stretch or pull too much while making alignment along the door edge. After everything done, I used the hair dryer and pressed a bit to make sure all stick well. Much much much easier to stick than I thought. Very highly recommended.

Of all the protective films I've worked with...doing the doors edge is probably the easiest and the results are fantastic. Starting with just the top of where you want to start along the door's edge. Give it an extra inch but don't press the entire thing just yet. Press just a bit only that it holds on. Don't pull the backing all the way off already. The trick is press down against the tape while pulling the backing on the back side. This should be easy to do with the backing partially already pulled and continue to hold down film and slowly observed the guide of the film while doing this. Once you have the film to where you want to stop go away and cut it off. Now, with only part of the film press on, gently guide the rest bit by bit until you're the film gets fully pressed into the inside of the door's edge. Towards the uneven curve, this is where you need to be patient and press down firmly going towards the inside. This will ensure the films adhesion. When you take this approach, there should be no bubbles as you're going but by bit. The clear film and the width of it is literally invisible unless you focus on it when. Looking at the doors edge for the film. Love that the film is stretchy to work with the curves and corner. The appearance from a distance like I said before is basically invisible unless you try to look at it

El producto cumplió con las expectativas que necesito en calidad y apariencia Me parece excelente

This is a great option for capable and patient DIYer’s. Product is of high quality and be sure to wipe your door edges with alcohol prior to applying. I used a heat gone for 1-2 minutes to ensure adhesion. Worked great!