Subwoofer Amplifier TDA7498E Mini Subbass Amplifier Digital Class D Built-in Subwoofer Amplifier 220W x 1 Fosi Audio TP-02

This amp was purchased to power a Dayton BST-1 Bass shaker. It does it with out a sweat. It is used on a sim racing cockpit under the pedals. It never goes over half as the rig would just vibrate to much. Perfect when using Simvibe software on PC, clean sound and very powerful. I have just got another to go under the seat, so two amps, 2 Dayton 50watt BST-1 bass shakers. Perfect combination. Would easily recommend for Bass shakers. Cannot verify for music as not tested, used for that.

Nutze den Verstärker für 2 Bass-Shaker von Reckhorn im Parallelbetrib (4 Ohem). Funktioniert gut und die Leistung ist mehr als ausreichend.

Acheté pour amplifier le son de mon ancien mais bon actif subwoofer d’une vieille radio que je comptais jeter , suis tres content du résultat.

Ok i have now had my unit for almost 3 years powering a buttkicker mini in my sim rig and i really cant put it over a third as it rattles the whole rig with zero problems have a m04 too and that doesnt even compare probably getting another of these to replace the m04 highly recomended although i would not really get it for anything that needs more than 100w rms @ 4ohm i havent tried it with 2 ohm but it would raise distortion and wont get more than 108w from the power supply anyways so yeah 100w 4 ohm load perfect

This little ripper replaced a home-built subwoofer theatre amplifier that kept our movies “thumping” for over 20 years. It weighed about 4 kg with a massive torroid coil transformer feeding the amplifier push-pull circuit. No matter what hubby did, he could not get rid of the low frequency hum when no input signal was coming in from the Yamaha theatre receiver sub output. Apart from that, it thumped the passive subwoofer speaker for two decades. We decided we needed a replacement for “old hummer”and chose this unit. It arrived and I was a little taken aback - it is 1/4 the size of the previous amp. I wasn’t sure what to expect. Needless to say, I need not have worried. This little unit packs a massive punch into the 8 inch, 6 Ohm subwoofer speaker and when there is no input, it is as quiet as a church mouse. Bye bye humming... We have to have the FOSI set at about 1/3 to 1/2 volume otherwise the sub overpowers the rest of the theatre sound and starts rattling our French doors leading into the theatre room. I get that it is new and you can never be assured of the longevity, but the quality from the outside looks and feels good and the output at a low volume setting is simply amazing - despite its miniature size. Clear and concise. And no idle hum. :-) Long may it stay this way!