Polly Plastics ブラックカラーペレット 成形可能プラスチック用 | 50g (1.7オンス) | ブリリアントブラッククリエーションを作成 | 米国製

This was easy. Just put in some pieces, mix it up, and if it isn't dark enough, put in a few more until you are happy. One tip, when it hardens it does harden less dark so adding a few more to keep it black instead of dark-gray is the way to go. You also get a lot of these in a package and it does not take many to darken the plastic. Good value for the money. Does not stain your hands when mixing.

I have used this for fixing a key chain ring for my apartment key fob, which worked great. It dries really fast so you have to act fast when using this for something. I also used this for a laptop I rebuilt. One of the tabs broke off and wouldn't seal the laptop case correctly. I was able to use a little bit of the polly plastic pellets to adhere to the tab in the laptop. This saved me time and money because the part was so small. I will consider purchasing more as I have a ton of projects I can use this for.

For any of the colors including black, don't just throw in the pellets into the white ones ... instead, heat up any color by itself and when hot press it out in a thin disk ... use a drinking glass .... make various disks with each of the colors . Now when you want to color a project, melt the white pellets and using scissors cut a narrow strip of one of the disk colors, the narrower the color strip the lighter the color will be in the final white/color kneading ... too light, cut another disk strip wider, or narrower . You have perfect color intensity control with this method instead of just throwing color pellets into your white ones ... These pellets are smooth to the flow after heating and blend really well .... if you decide to ignore my advice then just remember to start with a lot less pellets than you would think ... a rounded teaspoon of white pellets needs only 4 black pellets. they dont automatically mix, you must knead them into the white pellets and it mixes together like clay epoxy glue mixes do.

Takes slightly more pellets than suggested to reach the desired color level. Doesn’t matter, the products are great.

I have worked with this kid of material before. It was used on a clutch line that was rubbing against parts of my Harley and scrapping the lines surface off. I covered the line with the plastic while it was molten and it adhered quite effectively. The clutch line was black so it matched.