Renogy (レノジー) インバーター P2 1000W 純正正弦波インバーター 12V DC~120V AC オフグリッドソーラーパワーコンバーター 家庭/RV/トラック用 5V/2.1A USBポート内蔵 ACハードワイヤポート リモコン付き

I bought this 1000W on a promo mainly to run my chest freezer (149W) and fridge during an extended power outage. This model is great for that and barely dropped the power in my 100Ah LiFePO4 for about 8 hours. Already have three 50W hobby solar panels so in theory could extend for days. This model does not have enough power for a microwave (mine is 1300W) but I was aware of that when I purchased. Recommend you use a Kill A Watt device to determine before you place order. Cables are heavy duty and fan never came on during this minimal load. Love the fact it's pure sine wave, I can move it to friends house/camping with battery or run /charge off of car as well! Way cheaper and lighter than those solar generators if you already have some of the components

Works exactly as advertised, very happy with the purchase.

I have this set up to run some essential equipment, I have 200AH 12V LiFePo battery, charge controller and this in my setup - Absolutely rock solid - I put a scope on it - and it really is a pure sine wave - To be clear I am no where near the upper limit for this unit - I barely hit 100W at peak - so I can not speak to how this unit behaves under heavy load - BUT - I intentionally bought an over sized unit for this application so I would not have to push the limits and keep the unit as stable, cool, and reliable as possible - If possible it is better to make sure your supplies are markedly larger than your expected load.....

I measured the output voltage using an oscilloscope and a multimeter and they both said about 118 Vrms. I used my refrigerator as the load (about 300 watts). The inverter is stamped with 110 VAC but the output is closer to 120 Vrms, and didn't seem to change much with load. I also tried my heat gun which has a high inrush current when you turn it on which caused startup problems on a different 1000W inverter. This inverter handled the heat gun on its low setting which is 500 watts without any problems on startup. I also tried the heat gun (briefly) on its high setting which is 1200 watts and it worked fine. The cables are 4 AWG wire and the terminal eyelets have an inside diameter of 8 mm which is the size of the bolts on the battery connections of my 2020 Nissan Rogue. I bought two Anderson Power Products SB 120 connectors that I will use to make it easy to connect the inverter to the battery. The Anderson part No. is 6800G2 which includes 4 AWG contacts that I will solder onto the cables after I cut them in half. These connectors are rated at 120 amperes.

Fonctionne très bien, pas vraiment bruyant. Un petit peu de scintillement avec ampoules LED sans plus. Je suis satisfait !