70mm 12ブレード EDF ダクトファン 6S ブラシレスインランナー 2680-KV2200 モーターモデル ジェット機

Only docked the 1 star because the intake lip isn't removable. Installed this setup in an original parkzone Habu. This thing absolutely cooks on 6s. Power to weight is better than 1:1 now. Running a youme 6s 3300mAh 50c pack gets me little over 3 minutes of flight time, 4 minutes if I really keep the throttle back. Turnigy thrust 70 amp esc only gets slightly warm. Will update with real numbers once I run it on the watt meter. Video is WOT pass after about 2 minutes of flying.

This is by far the most powerful replacement 70mm fan assembly I’ve had. Unlimited vertical. It runs well on 7s.

Sure so much force. Not used it on a model but just in testing very good

I bought the Xfly 70mm 2200kv edf system to try and improve the top speed and shorten takeoff distance of my FMS F-18 SuperHornet. This system did exactly that and sounds freaking amazing while doing it!! I’ve hit a top speed of 133.6 according to my Spektrum GPS module which blew me away! Also takeoffs are half the distance of the factory 1900kv unit. I’m running mine on a Spektrum Avian 100a esc and a Yowoo Graphene 3300kv 100c lipo pack to get the most out of the unit. I highly recommend picking one up if you have a 70mm edf jet that you wanna wake up and make an animal out of!!

Thanks for this EDF! I really like the material the fan housing is made from. I replaced my old edf in my 70mm F-16 with this inrunner. The kv rating of this motor is 160 more than the outrunner i had in the plane. The outrunner was 2300.It sounds better too. Delivery was fast and it was packaged really well.