AUTOKAYBIKEQ-CP-005_2 Armrest Center Console Lid Truck Leather Synthetic Cover Skin Gray Fits for Dodge Ram 1500 2500 3500 2002 2003 2004 2005 2006 2007 2008

This piece seems to be a decent quality. I've had it for a couple months and haven't had any problems yet. The fit is ok but could be better, also installing it is kind of a pain. I had to buy a piece of 1/8 cable to wedge into the console lid piece all the way around to hold it down since I don't have a staple gun that works for that thick of plastic that the console lid is made of. You will most likely break some of the pieces to your console lid because its not made to be taken apart so just know that you will probably have to buy that stuff also.

When I removed the cover from the package, it looked flimsy and poor quality. I found that it fit the armrest well and looks pretty good when installed. You are going to come up with a method for securing the ends of the material to the plastic backing of the armrest. But once you do that, it goes on easily. I attached some of the material using a stapler, and also some quarter inch screws to anchor the corners. Expect to break some of the plastic tabs when you initially disassemble the armrest. I used some screws to fasten the plastic trim piece to the plastic backing of the armrest pad. This is not difficult and greatly improves the looks of the armrest.

It worked, I broke a couple clips taking the old one apart, but over seems to be a diy project. I feel has if I had to over stretch around the corners to make it where I could have enough material re-staple it. If it had 1 more inche of material would fix that issue.

Not bad. Removal of old / install of new isn't horrible. Line it up, staple one side, stretch and staple the other side - easy. Would have been nice if there was more of the 'extra' material, no big deal. Comes wrinkled from shipping - let it sit in the sun, use a hair dryer or heat gun, etc.

This product provides a low cost solution. There are much better options available but fine on a budget. Installation requires epoxy and patience. The overlap material where you attach to the underside of the arm rest is too small (should include more material). Try not to break the clips when removing the plastic trim under arm rest !!

It worked well. But the ears that fold under are not as long as the OEM cover. So it is a bit more difficult to secure. The back side is made different too so spend some extra time getting it secured first.

Easy to install. Only thing I wish was different was the string part to tighten it to the console. Overall a great buy

Take your time. Install the string end first; in the recess where the plastic guide was snapped in. Pull tight all the way around and start stapling. Color is not quite as dark as the original, but looks great.