HogueHandAll Beavertail Rubber Grip Sleeve for Glock 26, 27, 29, 33, 39 (Gen 3 & 4)

GREAT GRIP...CAN TELL THE DIFFERENCE AND HELPS KEEP THE FIREARM SECURE IN YOUR HAND WHILE FIRING...nice recoil absorption and get your sights back on target! ONE PIECE OF ADVICE ON INSTALLING....I BOILED WATER TO BETWEEN 80 TO 100 DEGREES POURED IT INTO A LARGE BEER MUG AND SOAKED THIS THING IN THE WATER FOR ABOUT 3 MINUTES...THEN TOOK IT OUT WITH A PAIR OF TONGS SPRAYED THE INSIDE WITH WINDEX AND SLID IT ON THE HANDLE...NOW IT'S TIGHT, SO ONCE YOU SLOWLY GET THE EDGES ALL AROUND THE BASE AND START NUDGING IT UPWARD, THE RUBBER SHOULD BE NICE AND WORKABLE TO WHERE YOU CAN SLIDE IT UP, ONE SIDE AFTER THE OTHER, UNTIL YOU GET IT IN PLACE, ROTATE IT A LITTLE (MAYBE) UNTIL IT'S JUST RIGHT. IF YOU SOAK IT ENOUGH YOU DON'T NEED PLIERS. I BOUGHT THREE OF THESE ONE FOR EACH PISTOL AND FOR THE FIRST ONE I USED PLIERS ON MY G27 WITHOUT WATER, WARMING, OR WINDEX AND THE PLIERS RIPPED THE RUBBER ALL UP...SO NOW I HAVE TO BUY ANOTHER ONE FOR MY G27 AND TRY AGAIN AFTER I STARTED TO GET THE HANG OF THIS AND GET MY RHYTHM GOING - FOR MY OTHER TWO (G23 AND G19) I WAS ABLE TO SLIDE ON FAIRLY EASILY ONCE I GOT THAT SYSTEM IN PLACE! READ THE REVIEWS OF THOSE WHO DID THIS BEFORE ME...TRUST ME, IT WORKS! GOOD LUCK! AGAIN GREAT GRIP!

Perfect fit for my MP5

Slipped on my Glock with some effort but once in place it stays there. Fills out my Glock grip for a more comfortable fit to my hand, has a small amount of recoil absorbing quality and a more secure grip under adverse conditions.

Used for CZ P10s grip. They only make one for the C and F read on a forum that this would fit the S and it does. Short by about two millimeters but almost perfect

Almost gave up at the 20 minute mark, but made it at the 35 minute mark. Tough install! The glass cleaner loses its slipperiness very quickly. The suggested plastic shoe horn was useless for me. Used my Swiss Army knife to shave down the end of a chop stick to a flat that I could use to lever the front of the grip onto the stock. Pushing it on from the outside was impossible past a certain point. Outside pressure does not help it slide. I used the screw driver/bottle opening on my knife to insert between the rubber grip and the stock and lever it a little bit at a time and that worked. Not sure it is thick enough to help with recoil, but improved grippiness should help. I think I like the increased fatness.

Perfect fit.

Perfect fit. Good quality. As described. Recommend this for your p365.

Be careful when following Hogue’s instruction video. As shown in the video, when I put it in boiling water and attempted to stretch it. It popped and broke into. I’m buying another and trying it one more time. Heads up, don’t stretch it too hard.