iAnder Premium Tempered Glass Screen Protector for LG G2 - Screen Protector for LG G2

This is fits like practically all the others on the market, leaves the edges not adhering completely to the screen surface all around for the G2. This protector also covers up the front camera, some might find it appealing, others may not want it.Coming from the standard screen protectors where one has to be careful and smooth out the bubbles, this has been an easy application. The tempered glass protectors practically adhere by themselves. Just make sure there is no lint in between the screen and the protector, align it, press in the center and it adheres outwards. Do not bend it, it is not made to be applied that way. Great feel also compared to the standard screen protectors.It's a tradeoff, protected perimeter, just be aware you end up with the edges not on the screen due to the G2's curved edging. If you want a complete adhering and tempered glass, MYBAT is the one to get. However, you give up the edge protection as MYBAT's protector is smaller in size. Some people don't like that.

After reading all the review about how nice the newer style of glass screen protectors are over typical plastic ones, I decided to take the plunge on my new LG G2 and order one of these. I have installed countless plastic film protectors and they are always a challenge to get installed just right and not have any bubbles. I received the iAnder one and read through all of the instruction after I received it. The instructions are written in typical broken. English and are almost useless if you have never installed screen protectors before.I went through all the steps of getting the screen completely clean and spotless and set this glass protector on. I then simply tapped in the middle and I watched the rest of the screen adhere like magic. That is where my amazement turned quickly into disappointment. Because of the LG G2's curved edges, there is roughly 1/8" of an inch all the way around that does not stick down. I tried to capture this in the picture. Not only that, but the phone now feels much heavier and almost unbalanced as the screen of the phone is much heavier.I left the phone alone for two days hoping this would improve over time like a wet app screen protector...no luck. I threw on my new Diztronic case for this and immediately it caught on of the corners and started peeling the screen protector up. I can only imagine after my phone travels in and out of my coat pocket how this will work. I will be removing the screen protector and sending it back for a refund. I hope to find a better fit tempered glass protector for my new G2, other wise I am heading back to using standard film ones and replacing them hear and there.

It's okay and isn't really hard to put on. I was very careful and took my time and got it on no problem. The bubbles went away and that was that. Only issue I have rally is that it can be rather annoying to put on. You really have to center it on the screen otherwise it can, in a rather small yet noticeable fashion, leave one side of the screen covered and the other showing just a bit. Maybe I'm asking for too much or just don't know enough about these products but I would like to see one that covers the entire front side of the phone.

The only downside to this screen protector is that it doesn't have a fancy smudge resistant coating. It does have the silicon film adhesive that practically vacuum seals it to the screen so there are no bubbles. And it perfectly covers the screen with about 1 mm extra on each side of the illuminated area. No lifting caused by the rounded glass of the G2. Fits perfectly with a diztronic case.It does cover the front facing camera to protect the lense. But it doesn't cover the proximity sensor so there is no interference with it's function.Update - I was thoroughly impressed that I could remove this screen protector and transfer it to a new phone when I needed a warranty replacement. I lifted the edge with a razor blade and let it slowly un-bond from the screen. It resealed to the new phone with no issues.

For the price, the screen protector is OK, but there are 2 problems with it:1. If the protector is centered on the screen, then the front-facing camera lens is covered, so that necessitates placing the protector lower on the screen in order to leave the camera lens uncovered, but that exposes a small part of the upper screen to scratches and other damage. I suppose I could have used scissors to trim off the part of the protector that covers the lens, but this protector is supposedly made for the LG G2, so why should consumers have to modify it? Also, some people might not object to having the camera lens covered, but I don't want anything obstructing the camera.2. There are 3 small air bubbles that I can't remove from under the protector. One is at the top, just below the camera lens, and the other two are in the lower left and right corners.

This product fits the needs of protecting the screen, but it appears a defect prevents it from being the Crystal clear that it should be. I was able to apply the protector on the screen without bubbles or dust particles getting trapped, but for some reason, the upper left corner of the protector just did not want to stay stuck to the screen. No matter how far to the right I position the protector, the protector keeps lifting up, I even tried to add some weight on it, but once the weight is lifted, the protector lifts up as well.Overall, it does the job, just doesnt do it pretty.

This thing has saved my g2 twice already, it's already paid itself back. Fits just right, no issues with it all. I would recommend that when you're trying to put it on, wash your hands, don't touch anything that may leave little fibers on your hand or anything and stay away from a.c. vents. Or you might end up with little dust things that will prevent it from having any bubbles. The installation is fairly easy, just follow the instructions.