Milescraft 4009 Fence Clamps

larger than expected but sturdy and workable,

Well made and works great

These clamps are great for holding corner clamps in place. One thing I noticed is that the end swivels freely, so I put a 3/8 - 16 nut on the angle end and locked it in place (see picture). That helped to stabilize the clamp to work more like a standard c-clamp. I found these to be very helpful while using 90 degrees 5.5"x 5.5" corner clamping squares for right angle. The round angle end fits perfectly in the holes in the corner squares and gives a tight clamp with little effort. I also like that the opposite end has a nylon protective end which the other more expensive clamps only have metal. This was a nice addition to my c-clamp arsenal and they worked smooth and tight for my woodworking needs. I would buy them again and they are less expensive than others offered on Amazon.

These clamps are excellent for numerous tasks. I purchased them to hold a sacrificial fence to my table saw, and they work perfectly. The price is great since a lot of other companies charge triple or more for the same thing. I plan on purchasing a couple more for some other clamping jobs so I can keep my fence clamped to my table saw. I highly recommend this product. Hopefully this helps you with your decisions.

These clamps do exactly what they’re supposed to do, with solid travel, predictable fit, and compatibility with common shop accessories like 1‑2‑3 blocks. The clamps are incredibly handy, especially when paired with a table saw fence. Their most common job is clamping a stop block to the fence so you can make repeatable crosscuts without the workpiece ever touching the fence during the cut. The generous travel range makes them compatible with wider fences. A note on the rod size: nearly every manufacturer claims a “3/8‑inch rod,” and this one repeats that in the title. At least the description clarifies that it "fits into a 3/8‑inch hole", not that the rod itself is 3/8. My calipers put it just over 5/16", which does fit a 3/8" hole. One of the nicest uses for these is pairing them with 1‑2‑3 blocks as stop blocks. Since those blocks already have 3/8‑inch holes, you can skip drilling a custom wooden block and just drop the clamp right into a hole in the block. It also makes the math dead simple: add 1", 2", or 3" to your fence's cut width measurement depending on which face of the block you’re using. Some of the holes on 1-2-3 blocks are threaded. These are a more snug fit; however, you can always just use one of the other nearby holes.

Simple and cheap. Just spray some dry lube on the screws as they're a bit harsh.

Milescraft does it again! Not the only fence clamp out there, but these are very solid and extremely affordable. Span up to approximately 6”. Solid STEEL threaded rods and cast aluminum frame. Knob is plastic, but adequate for the task. So far, I’m 5 for 5 with Milescraft accessories. They do the job for a fraction of the cost of the “boutique” brands you see all over YT.

Pack of two. One of which was bent upon opening package.

Ótimo produto! Eficiente!

all good

I initially bought these clamps to make stop blocks for my chop saw. I also took a 4 foot piece of 1X2 hardwood (scrap oak) and clamped to my fence on my table saw as a fence extension using these clamps . Worked like a charm. Just drilled out some 3/8" holes using a drill press and these clamps hold the board perfectly as a guide for longer boards that I cut. I liked it so much I just ordered an other pair. Sturdy material that won't bend and holds very well. I am extremely satisficed with this product. Highly recommended.

Buena calidad y muy prácticas, muy satisfecho con la compra

I bought a similar product on a certain Chinese market site. Only 1 arrived, my mistake! These were only slightly more expensive but of far superior quality.