Table Saw Sled Kit, 17" Predrilled Miter Bar, 5-1/2" Hold Down Clamp & 3" Fence Flip Stop, Fits Standard 3/4" x 3/8" Miter Slot, Ideal for Woodworing, Router Table, Bandsaw (72218)

These work fabulous

Made of adequate heavy material. I Dado the perfect dato so that it fit snugly, ran some glue along the bottom and clamped it in place over night. Fits a Craftsman 3/4 by 3/8 miter perfectly with less than .019 inch slide play. Great value considering the weight of the material it is made out of

Easy to install. Very slippery. A little too skinny for my Dewalt 7491rs slots though. Tightening the screws doesn’t increase the width enough to eliminate the slop.

These are very nice and smooth, the drilled holes are clean and beveled, and they come with some screws. Stock up for your jigs and other uses.

Bought to make rip sled for older Sears 9” table saw. Fits fine in table slot, just don’t over tighten screws, they will make plastic bind in saw track. Easy to install, place a penny or washer in track, a couple of drops of super glue, then flip over & drill and screw. I have enough for a couple of jigs.

Good fitting bars

Great for making your own sled jigs. Lghtweight and easier than trying to cut miter bars yourself. Only problem I have had is that my double sided tape did not stick well to them when tying to attach them to a sled, but a different brand tape might work better. They slide in miter slots with ease when aligned with sled correctly.

After using it, I can say it was fun, very useful, and does its job perfectly. I really enjoyed it.

Was making a sledge for my table saw, plastic runners fitted perfect in my table saw and was ideal for the job I bought it for,

Works great, but needs some care to use. These have a bit of play in my miter slot. When attaching to a sled, place tape on the edges to keep against one edge of the slot. Then, when you screw them in to the sled, tighten by hand until the plastic bulges just enough to remove any play, which requires some trial and error.