Rust-Oleum 318347 Automotive Peel Spray Coating, 11 oz, Matte White (Pack of 1)

I used this to blacked out my grill and emblem. Just follow the directions when applying the product. I made sure I cleaned the grill really well with rubbing alcohol before I applied the product. Start off with a light coat first and wait about 5 minutes. Then a light second coat and so on. Make sure you wait about 5-10 minutes before you apply the next coat. It blends in together really well. I did about 5 coats or more. Will see how long it lasts and how tough it is. Only time will tell.

No problem applying 4 coats with 7 minute drying time between coats. Follow the directions on the can but (THE CAN IS MISSING ONE VERY IMPORTANT DIRECTION.) You need to go to the Rust-Oleum website and read the Product Overview statement.The missing instruction that you need to follow is -- Begin removing tape and other masking immediately after the last coat has been applied to keep clean edges. If you wait too long, the coating may adhere too much to the tape.This information was not on the can so when I started to remove the masking tape some of the coating started to peel off with the tape. Repairing the damage was easy and the Rust-Oleum Peel Coat is a great product. It looks good, was easy to apply, and it would have been nice if they had put all the instructions on the can. Be very careful removing your masking tape.

This is a good product. Just make sure that you properly prep the surface. the only reason for 4 stars is that if you apply it a little on the heavy side it can tend to lift showing small cracks. So take your time. If you don't like it, just peel it off.

This was a very easy way to change the appearance of a very beaten up and paint peeling off our car vehicle hood.I was not scared to apply this cause I knew I could peel it off if it looked bad. It ended up in hearing so well and had a slight graphite glint. And looked really sharp. Course it was an older car so everything was an improvement, but it really looked nice. I was a novice applicator, and it looked good. Buy some good masking tape. I used 3M tape.

NOT gloss, this is Matte if anything, can be very runny

I used this on my 09 f150 tailgate. I was washing the car and a chunk of paint fell off. Instead of painting the whole thing, I opted for painting a black line where the paint fell off (bottom of tailgate), It worked great. My wife thinks it looks more refined. The paint is very forgiving and hides imperfections. Best thing is that it comes off if you mess up! Also used it on my wife's 17 Hyundai Santa Fe, the bumper was looking rough so I used thiner to clean it up, sanded with 400 grit sand block and applied a coat of paint. Looks like new! Only thing is that I had to remove existing paint with thinner as it started to bubble up when I originally applied the paint. Well worth my money!

I shook this can for ever and then my brother did too. It sprays out runny like there's water in it.

I used this to black out the emblems on my GR86 and it looks awesome. Very simple and easy to use, followed instructions on the can, probably did around 8-10 coats? No top coat, no issues when washing the car. This picture is a month after application, after 4-5 hand washes.

The media could not be loaded.  Its a fairly easy thing to handle only if you have done your research on how to use such paints. My concern is, how much heat resistant is it for alloys.I tried on my rusting chrome part of scooter and it can get damaged if scrubbed hard or a mild scratch from nail. Maybe scrubbing out chrome and applying base coat bonding agent makes it stronger.I would like to ask the guys who did their alloys, how sturdy is it there?

Not good

Awesome, durable, bright

Easy to paint

So far so good... Have been applied to my car alloys.. Will have to observe for next 2 weeks to get whole picture