VCELINK RJ45 Connector Tool-Free, CAT6A Field Termination Plug, Gold Plated Modular Plug, UTP CAT6A Connector Toolless for 23 to 26 AWG Network Cable

I bought this because I don’t want to spent money on the other tools to make a rj45 connecter. After a few times making this work. It connects with my laptop no problem. Got full 1.5Gpbs speed to my laptop.

What a relief, after so much stress with the cheap crimp connectors. I had those ones w a separate boot, and many crimps later, I still could not do it. But these crimp connectors are so much better! My connector worked at the first try. Yes, they cost more, but the time and frustration saved is worth every penny. Fully recommended. Will definitely buy again!

Great and simple solution, it works just as advertised. I was not able to connect a bullet camera because of the connector is a little big for the limited space to connect inside the PoE camera.

If they are shipped fully assembled it's extremely hard to get the load bar and plastic out of its cover. So not only would I not be able to use them several times I might not be able to use them the very first time. That would be too bad because it's a great idea and solves a particular problem I have. I'm going to try a few more times before returning them. The company should put the pieces together lightly, rather than fully assembled, and send a diagram of the disassembly and reassembly steps, and maybe a youtube vid. Addendum: I used a little screwdriver, like the ones you use to fix watches, pried the top up a bit and then it was all smooth sailing. Changing my eval from 3 to 5 becasee it solved my problem, eventually.

Works well with a wire tap in the tooless design. The first set of wires goes through a pass through and does not have a “pinch point” to hold the wires in place like the second set of wires does. You’ll see what I mean when you put the second set into their “clasps”. This causes the first set to come slightly loose or not be pulled taught to get the wire tap to work effectively. I got this working by slightly lengthening the first set of wires to where they are picked by the end when you press into it and that worked for me. Simple change with the first set having clasps would resolve this design issue and make this 5/5, with out it, still a good connector but… 4.5 and you still need a wire stripper, so not really 100% tool less, just saved buying the crimping tool is all