Car Window Weather Stripping Molding Trim Belt,Compatible with Honda Civic 2006-2011 4-Door Sedan, Replace#72410-SNA-A01 72450-SNA-A01 72950-SNA-A01 72910-SNA-A01

These worked great and look like factory items.

Easy install. This window molding trim installs in about 30 minutes. Fits like it came from the factory. Quality is impressive.

I watched a YouTube video to learn to remove the old trim and install the new trim. It seemed simple enough, but it was a little more complicated than the instructions in the YouTube video. Looking back, it is harder to remove the old trim than it is to install the new trim. Don't forget to wash your windows and door beneath the old trim before installing the new trim.The trim pieces do not include any instructions for installation. The pieces are individually wrapped and labeled. If you don't have one, you will need to have a plastic pry bar to aid in removal of the old trim. In the video I watched, the installer used a plastic pry bar and a screwdriver to remove old trim and broken clips. I ordered a plastic pry bar kit that included one metal pry tool and I used that along with the plastic pry bar to lift the old trim up and break the first clip. After that you can use your hands to pull the trim the rest of the way off. You will break the old trim clips removing the trim. The old trim is garbage after that.I read reviews prior to ordering and was very hopeful based on positive reviews, but also completely expected the trim to not work on my car. I installed my left rear trim piece first and was sure the one review that mentioned the clips didn't work was going to be my experience because the piece was not clicking anywhere. So after 30 minutes of struggle, I did not think the trim was going to work since the clips did not click into place as instructed in the YouTube video and the trim could be easily lifted back off the door.I asked someone else to take a look and they suggested pushing the center of the clip forward just a bit to give it room to grab under the door. Following that advice, I used a screwdriver to push or bend the center part of the clip forward. This is the part of the clip that will catch under the door frame and keep the trim in place, and after that bend, the trim did click in place and could not be moved. The YouTube also mentions that once it clicks in place it is permanent, so make sure it is aligned correctly before you clip it in place. I clicked my right rear in place about 1/4 inch too far back and it took a lot of pushing, pulling, and shoving and a lot more swear words to finally get it to slide into place and close that gap at the front of the door. Lesson was learned and I made sure to double check the fit before clicking the other pieces in place.If I'd known to bend the center of the clip out to help it catch under the door, removal and installation would have probably taken an hour. I wasted about 30 minutes trying to make the first piece work before I gave up and asked for help and then it took me about an hour to finish up, including time to clean the windows and door beneath the old trim. All of the pieces fit perfectly and they look like factory parts on the car.

Nice and easy installation. Recommend using YouTube to watch removal of old trim. Doesn't hug the window as tight as I would like but I did not have the original trim on to compare to because I bought the car used and the original trim was basically disintegrated from the weather, only compared to my other vehicles. Price was good for what it was intended to do.

These were actually very easy to install. I had seen videos saying you had to take the whole door apart and then I found one guy who said basically just ripped them out. Don’t worry if the clips break on the old ones because you’re not reusing them anyway! Following his advice and the video on YouTube I quickly remove the old ones from the car, cleaned the area and slid the new ones into place. They snapped in perfectly and look phenomenal. Check out the before and after photo and zoom in so you can really see how bad the other ones were.

Only thing I noticed. It the tabs to lock the strip in place is flimsy. It should be stiff allowing the tab to lock into the slot on the car door.Fits great!Easy install!Excellent condition!

Good fit, easy install. Fraction of factory cost. Happy with purchase

It fit to my civic very well. Easy to install and the cost of this weather strip is much much cheaper than Honda dealer’s one that they sell. I will definitely recommend to some other Honda’s owner to buy this as replacement.