Perfit Liner 5.0 FT (61") Bed FRP Hard Tri-Fold Tonneau Cover Fits 2019-2025 Ford Ranger Truck Cargo Hard Topper, 3-Folding | Not fit Cargo Management Rails

It was pretty easy to install. I was able to do it on my own which I appreciate.It looks so good!

I have a 2008 Ford Ranger Sport. It fits perfectly. The instruction could be improved. In order to lock in the end cover one needs to pull the string and pushes top end part down to snap in place. My old cover I was replacing only needs to push the end part down by hands to snap right in which I personally would prefer.The clamps could be more sturdy and the screws of clamps need to be tighten from time to time until they finally settle. I thought the screws are little thin. I was afraid to strip or break them when tightening them.Overall, it looks good and in good quality. I would recommend it.

This thing is great. It’s really made well. The extruded aluminum frame is really strong. The soft cover it very thick and strong also and the velcro it nice. Not the cheap weak type. Very easy to install and it fits perfectly. The clamps work well but I may drill through and put stainless screws and locking nuts but not because it needs them. Just because I prefer it.The only thing is, at first I thought something was wrong with it. Seems you can’t really lock the cover down if the tailgate if closed because it has a lot of tension on it. Just open the tailgate and it locks right down.

Had one and was well used. Bought this one and it is super nice. Would buy again if needed.

The cover fit fine and looks great. The problem was the all thread bolts were to short. My 2024 has a cover around the bed top and the bolts have a hard time clipping under the rail

Very nice looks good

for the price, this is totally worth it, only problem is that all the mounts don't fit. only four out of the six mount up. the four that mount up are shown in red (this applies for both sides of the bed) and this is because there is a overhang that the mounts can grab onto. but the two that don't fit, are in green, and this is because the bed and the factory bed rails touch. so there is no way for the mounts to fit around the overhang.but other than all that, this is honestly the best cover for the price, it seals all water out, it closes and opens just fine. not sure how it will do with all the weight of snow ontop of the cover yet. if it holds up just fine against the weight of slushy snow and heavy snow i wont update. but if it collapses or rips or something ill update.so far so good with this

Cover came well packaged. I had watched a couple of videos on how to install, but the instructions were pretty simple to follow. I had to trim a bit off the two side rails as I felt there was too much tension when I tried to close and latch the cover. Once I did that it closed and sealed well.