4pcs Hall-Effect Joysticks Replacement for DualSense PS5 Controller, 3D Analog Sensor Wheel Thumb Sticks Rocker Module Replacement for Playstation 5 Controller

Works great

These were just as described. Unfortunately, I lack the skill to install them myself and wrecked one of my son's PS5 controllers 🙁 The good news is I have a friend who works in the electronics industry. He was able to install them in the spare controller, and they ended up working out perfectly. There is no more stick drift, and the response time seems to be better than the factory controller.

Have two dualsense controllers with jitter on the right sticks. I had heard hall effects would correct the problem but didnt want to waste the high cost at the moment. And after having the same issue with ps4 controllers years back, I knew the level of work it would take to change these. I bought the tiny film with potentiometers first to try out. Those where a lot cheaper and it was a lot easier to just put a little solder on top of the original stick contacts. Tried those on my dead ps4 controllers and as I thought, it didnt do much. With those tiny film potentiometers you adjust on one end but the other side of the travel gets messed up. Those where more luck than a guaranteed solution. After a year finally saw this hall effect ones on a reasonable price and decided to buy them. Be advised this is a complicated replacement to do. The toughest part is removing the original ones from the controller. Controller can be opened with a quick internet video. But desoldering the old one takes A LOT of patience. If your up for the challenge it'll fix your dead ps5 controller for sure. Just take your time a dont rush. Once you get the original one off its easy putting the new one in and just taping the solder points. To calibrate them after, just go on the internet and look for a video. Its easy and again, PATIENCE is the key on removing the old one AND calibrating the new one. From a 50 dead zone setting on apex were down to a 0. Oh and I only replaced the bad one. The other joystick on the controller was fine. If it also goes bad along the way I'll just do the same.

I had my doubt that hall effect sticks are this cheap. And it's my first time soldering too I manged to not brick the board and it works. Didn't even need to calibrate it with gui. It was perfect and then I closed the case and the sticks would stay in place like the other reviews you may see. But the problem is the stick is tiny tiny bit taller than originals . All I did was push the stick covers nice and tight and everything works fine. P.S I was scared when I put it all together and it behaved the same way as other reviews here but use your brains it is PERFECT and cheap what else do you need.

Total waste of time and money. The L3 doesn't work on the first one, so I tried another and that one drift. The 3rd? L3 doesn't work. Installed the last one with working L3 and after an hour it just straight up broken, can only move in upper direction and nothing else works. Into the garbage they go.